Jump to content
SAU Community

Recommended Posts

Hey all.

I've done a bit researching but found nothing conclusive.

So here goes.

I have a few things to do to the GTR.

Fuel pump, front pipe, high flow cat, performance panel air filter and lastly turbos.

Now it makes complete sense to retune the car after installing turbos.

But I'm an impatient bastard.

Will I be fine to install all but the turbos and get a tune done when I put the turbos on?

I'm not expecting gains just want to know if I am in the clear, or is the car going to go retard on me and run rich...

Thanks for any input.

Link to comment
https://www.sau.com.au/forums/topic/385200-when-is-it-paramount-to-retune/
Share on other sites

well fuel pump won't require a tune as you could put the fuel pump out of a space shuttle on there and it wouldn't affect the tune (unless the old pump was dead).

air filters and front pipe and cat won't really make much of a difference so it should be fine to run them on the current tune. sort of depends on the ecu though and the quality of the tune. you can even run aftermarket turbos on a basic tune as long as you keep the boost down.

You could just get a dyno power run to check that the tune is safe after pump/cat/front pipe. If its not safe, just drive like a granny until you get the turbos+tune done. Agree with mad that it *should* be ok, especially if you keep the boost low, say, 10 psi. Remember the stock turbos can be fragile and can damage the motor when they let go if you're unlucky.

You'll probably notice gains from changing the cat.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Use a 2' length of hose (that's 2 foot, not 2 inches) as a stethoscope to localise the source of the ticking. From cam covers? From exhaust or turbo manifold gasket? From injectors? From lower down in the engine? Etc. Use a timing light to set the timing. Put Redline Lightweight Shockproof in the box. It's not the very best thing for the box, but it will take a box that refuses to engage a gear with other oil, and make it engage a gear. I had to put it in when I installed the R33 box I have in my car. It would not select ANY gear when running. Smurf jizz made it work. That was >10 years ago and I still use it. I'm stuck with it now. Failing that - rebuild the box.
    • Well done Duncan. The fuel tank bulkhead lid is also in great condition (some of mine were stuffed). These are now out of production and good ones like that are becoming hard to come by.
    • Wow that's a steal, you've done well there. 
    • Exterior LEDs R34 2Dr R34 4Dr Position Lamp T10 T10 Winker front T20S T20S side T10 T10 rear T20S S25S150 Anti-hyfla relay TYPE3 TYPE3 tail T10 T20W Stop Lamps T20W T20W High Mount T16 T16 back T16 T20S number T10 T10 trunk T10 T10 Interior LED Item No.     Map Lamp BA9S single-sided     Room Lamps T10×31     Trunk Lamp T10     meter Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     Liquid crystal section T6.5 pedestal     Winker T6.5 pedestal     High Beam T6.5 pedestal     3 SERIES METER Early T6.5 pedestal     final T6.5 pedestal     NISMO T6.5 pedestal     air conditioner Early Liquid Crystal T3     Late LCD T4.2 Short     button T4.2 Middle     Hazard SW T3 Pedestal Short     Keyring T5     Cigar Socket T5
    • Howdy all,   I had my rb25det S2 rebuilt and finally started it today but have run into a few issues  Engine sounds like a a diesel easiest way to summarise like small ticking, gets louder when revs are slightly adjusted  The engine builder repainted the engine cover leaving no where for me to go off with lining up the CAS so have it as central as possible so not sure it that could be affecting it?, changed the gearbox fluid too but won’t seem to go into gear when running, and only 1 to 4 when off having a hard time finding 5th and reverse anyone got any ideas or a base for me to start off? much appreciated 
×
×
  • Create New...