Jump to content
SAU Community

Recommended Posts

  • Replies 68
  • Created
  • Last Reply

Top Posters In This Topic

  On 28/12/2011 at 1:30 AM, Jetwreck said:

Am interested for sure......want to do one run as is and the go out for another a week or to after to see the differences in going to a bigger size injector with the e-manage.

That's lucky; it's normally that packed, you'll only get 2 or 3 anyway...whistling.gif

Link to comment
https://www.sau.com.au/forums/topic/386599-400m-drag/#findComment-6167109
Share on other sites

  On 28/12/2011 at 1:39 AM, scotty nm35 said:

Limp, blaming the EMU for your issues... Get it back in mate. :rolleyes:

yeh....I want to beat your previous best of 13.5 with the standard setup :P

Then crack a low 12 with the e-manage setup.cheers.gif

Link to comment
https://www.sau.com.au/forums/topic/386599-400m-drag/#findComment-6167254
Share on other sites

  On 28/12/2011 at 3:12 AM, Commsman said:

Where would that be Tom? Willowbank or is there somewhere closer?

Yeah, wed nights are best too

So many ppl on the sat so you only get a few runs

Link to comment
https://www.sau.com.au/forums/topic/386599-400m-drag/#findComment-6167759
Share on other sites

  On 27/12/2011 at 9:02 AM, Bronx said:

everyone needs to stop bitching and get your asses down to WSID ;)

haha. i wonder how long my clutch will hold doing 5krpm dumps :P

Not long

I have been twice and have wrecked 2 aftermarket JB clutches....

Link to comment
https://www.sau.com.au/forums/topic/386599-400m-drag/#findComment-6167783
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • If I drove to a typical petrol station, what would my choices of fuel be? 
    • Just cut the bottom of the guard out. It's no longer got a big duct, to a sealed box, or a restriction. It has all the cold air from outside. Also, that cai you showed looks terrible. Bends are NOT good for go gos!
    • Like I said, "black magic" LOL In the end,  it is what it is, and hopefully, what this here knuckle head has done is an improvement and not a hindrance Not that I actually notice any negatives now, or that I will get any seat of the pants benefits when all is said and done, but best practice says I shouldn't be pulling intake air from the hot engine bay  Famous last words: I cannot see it being any worse than what it is at the moment 馃
    • If the gases flowing in those two tracts had the same properties, you could maybe use such broscience. But the exhaust has a different composition, different normal density, different actual density (because of different normal density, and mostly because of the massively higher temperature), and different viscosity (again because of much higher temperature). Consequently, all of the fluid dynamics parameters that matter, that you calculate from these inputs, such as the Reynolds number, friction factors (for wall friction) and so on, are all incomparable.
    • And we shall have to presume that Canada is the same?
  • Create New...