Jump to content
SAU Community

R34 Tune Up


Ericjayrol
 Share

Recommended Posts

Hey =)

I keep hearing people say get your car tuned to unlock its potential, but I'm unsure of what's involved in a tune up, as opposed to a service.

What is actually involved in tuning up a non turbo R34? Is it worth doing on a non turbo? I think it might involve ECU mods and tightening bolts maybe?

I'm also looking for a good place to get the tune up done, My family has been to ultra tune. To avoid the defamation rules, I won't say anything, but I do not wish to go there.

Any help and advice would be appreciated.

Link to comment
Share on other sites

Generally it does mean the ECU side of things. When designing/producing a car, there are certain standards/restrictions that need to be adheard to. This could be carbon emissions, reliability requirements or even fuel consumption.

When a car is tuned, the tuner alters the settings to specifically cater for the exact car and circumstances by changing things like fuel maps ect to gain the power that was de-tuned out of the engine oringally for the reasons above mentioned.

You can't go to any garage to have your ECU tuned. It would have to be a place with a dyno and specialist knowledge/equipment.

It is not cheap and the gains to be had by tuning what I'd assume is a largely stock N/A skyline are definitely not worth it.

Link to comment
Share on other sites

What about a stock turbo 34?? Would it be worth it then? Also do they jst tune ur ecu or u need a new one/computer??

Also my 34 has been converted to manual since owning it, would a tune be also beneficial do to it being tuned for an auto ?? Sorry for the dumb questions but gotta learn some how

If it's stock it will be roughly the same as mad said, maybe a little more.

It's when you start upgrading things like your cooling or fuel systems you can start playing around, as you can run things more towards their capacity.

If your car is completely stock, for the price of a nistune ($1000) you'd be best getting a FMIC and a boost controller and putting the boost up to 12psi. You will see a larger increase from stock then a tune alone.

Link to comment
Share on other sites

What about a stock turbo 34?? Would it be worth it then? Also do they jst tune ur ecu or u need a new one/computer??

up to maybe 20kw on a r34 gt-t from a good tune if you are running a front mount, full exhaust and higher boost. if the car is dead stock then the gains would be much less. as was said, you will get more gains from doing those mods than just the tune. and on a r34 gt-t you can have a nistune installed in the stock ecu.

Also my 34 has been converted to manual since owning it, would a tune be also beneficial do to it being tuned for an auto ?? Sorry for the dumb questions but gotta learn some how

if it is still running the auto ecu then probably. it partly depends on how they did the wiring when they did the gearbox conversion. the autos are designed to only be able to be started in neutral or park. i'm pretty sure they send a signal to the ecu, which controls this. most people who put manual boxes in just trick the ecu into thinking it is in neutral or park all the time, so the car will start whenever needed. the downside to this is that the ecu has different mapping for park/neutral to when it's in gear. manual gearboxes have a switch in them which also tells the ecu when it's in gear so that it changes the mapping, but unlike the autos you can still start the car with it in gear.

long story short, if it's still running the auto ecu then i'd start by looking at getting a manual ecu for it and making sure that the gearbox switch is working properly. (a consult cable and progrum such as datascan can tell you this)

Link to comment
Share on other sites

  • 3 weeks later...

up to maybe 20kw on a r34 gt-t from a good tune if you are running a front mount, full exhaust and higher boost. if the car is dead stock then the gains would be much less. as was said, you will get more gains from doing those mods than just the tune. and on a r34 gt-t you can have a nistune installed in the stock ecu.

if it is still running the auto ecu then probably. it partly depends on how they did the wiring when they did the gearbox conversion. the autos are designed to only be able to be started in neutral or park. i'm pretty sure they send a signal to the ecu, which controls this. most people who put manual boxes in just trick the ecu into thinking it is in neutral or park all the time, so the car will start whenever needed. the downside to this is that the ecu has different mapping for park/neutral to when it's in gear. manual gearboxes have a switch in them which also tells the ecu when it's in gear so that it changes the mapping, but unlike the autos you can still start the car with it in gear.

long story short, if it's still running the auto ecu then i'd start by looking at getting a manual ecu for it and making sure that the gearbox switch is working properly. (a consult cable and progrum such as datascan can tell you this)

Hi Mad,

So if i had mine converted to manual (R34Gtt, FMIC, aftermarket Radiator, Turbo Back exhuast) can i just plug and play the manual ECU? Or there is wirings I need to swap around or cut or rewire??

If need to cut and rewire or whatever do you know which wires are they on the harness or pin number to which?? Cos I'm experiencing Rev cut around 6k or 6.5k mark. Is this to do ith the ECU??

Thanks

Daniel

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • I did a pretty ruthless clean up before I left townsville. If it wasn't a part to suit a car I currently have it was sold or binned. I have all my stuff organised in big tubs with lids that stack from supercheap and bunnings depending on who was cheaper at the time. Parts were sorted by either chasis/motor/Fabrication/general/electrical. I have a mezzanine that's 7mx2.3m and all lives up there. Easy to access when needed and out of the way.  I also have the issue of selling and dealing with scumplace/marketbook was actually going to list stuff today but couldn't be bothered as been stuffed around too much. I generally let a few people know I want to off load stuff and people pass it on to others to contact me, generally easy sale and I'm never looking to make big dollars. Rather it gets used than go in the bin. Next clean up will be around Xmas and if doesn't go on the s15 it's going bar 2 sets of wheels. 
    • Did a little bit on the V37 today. I bought this LED kit out of the US https://www.ebay.com.au/itm/125953603618. Best I could find online but didn't look great, in the end the quality was pretty much right and it did come with locations for each light including rear number plate and a few spares. The factory owners' manual was also useful with information on where to pop each light out without damage. I prefer the LED look as I use it daily including at night and the LEDs are both brighter and the white light is easier to read with. Vanity mirror comparison, LEDs just look more modern The glove box was the only difficult one (and the only one that was previously blown.....), steps were Open glovebox 50% but not fully open Push up on bottom of the box to unclip it on both side, not screws or pins to remove Remove the top stays at an angle, right side then left, because.... Before dropping the glovebox totally, remove soft close clip on left Then, remove 7 screws to release the glovebox surround Twist the globe holder anti clock to release it from the surround In this case, the LED globe supplied was wider than factory and did not fit, so I ground down each side about 1mm then inserted it Last trick, start engine to check the LED polarity is correct, the globe only operates when the engine is running (whether the box is open or closed) I also moved the 4G booster and wifi across from the Fuga, a little frustrating as I could not find a good Accessories ACC source anywhere in the boot so I'll run a wire from the cabin next time I get a chance. Also, unlike the Fuga the external antenna wire does not quite fit between the rear windscreen and the body so I think I'll have to drill a hole in the roof to mount it. Probably not that interesting for most people so I'll just post once complete
    • Pretty sure I could do but it would need to be exported and reimported as the current import approval is race only. But in practice there are plenty of other practical reasons it can't be a road car despite their potential value these days like stripped interior looms, cage to cut out etc Nah, no mods to it other than updating the roll age to current regs. It makes about 350 (laggy) kilowatts on the N1s at 18psi which is enough to push it around the place
    • This is it, folks! Our final event of the year... The big one, you all know and love - Putty Road! It goes without saying, but this is the biggest cruise in our calendar each year! A nice long drive, with a hearty pub feed at the end! Do you need much more enticing than that!?!? So make sure you wash the car, get your cameras out, block out the calendar, and get ready! We know you're all as excited as we are, so make sure you lock in the details and date below: Date: Sunday 8th December 2024 Meet Location: Corner Windsor Road and Groves Avenue McDonald's / KFC (3 Groves Avenue, Mulgrave) Meet Time: Meet at 9:00am for a 9:30am departure Destination: The Royal Hotel, Singleton (84 George St, Singleton) Map: https://tinyurl.com/saunsw-puttyrd Itinerary: We will meet at McDonald's / KFC on Windsor road and from there will head onto Putty Road. There will be a break at the Grey Gum Cafe (8679 Putty Rd, Putty) which we should reach at approximately 11:30am. For all the Newcastle folks this will be a good point to join up. From here we will continue on to Singleton for lunch. Please remember to fill up prior to heading onto Putty Road. There will not be a fuel stop until Singleton. To those running on E85, Freedom Fuel (old United) at Vineyard on Windsor Road has started selling there. At Singleton there is a range of servo's available including BP, Shell and Caltex. There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU:NSW and thus, treat others accordingly. • Any misbehaviour will not be tolerated and you will be asked to leave. Thanks guys and hope to see you there! 
    • Back by popular demand - we're lining up another Old Pac Run! Get your cars ready for one of the best night runs on the calendar! So without any ado whatsoever, here are the details for you to save: Date: Saturday 23rd November 2024 Meet Location: Cowan Truck Stop (Pacific Motorway - Refer to Map) Meet Time: Meet at 7:30pm for a 8:00pm departure Destination: Gosford McDonald's (65 Pacific Highway, Gosford West) Map: https://tinyurl.com/saunsw-oldpac Definitely an easy one for this cruise, meet at Cowan Truck Stop and jump straight onto Old Pacific Highway! Final stop at McDonald's which has plenty of parking all around. Please be mindful of the added police presence lately so best behaviour is expected! There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our track days. This is an official SAU:NSW event and will be run under a Motorsport Australia permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU:NSW and thus, treat others accordingly. • Any misbehaviour will not be tolerated and you will be asked to leave. Thanks guys and hope to see you there!
×
×
  • Create New...