Jump to content
SAU Community

Recommended Posts

if i had a car that ran 9 sec 1/4 mile, i wouldn't give a flying fcuk how quick it was on the street !! who cares ?

drag racing is from 0 to 400m, not from a green light to the end of the track, and a car that runs 9's on the track pulls around 220 to 240 km/h !!!! who the fcuk would do that on the street ?

  • Replies 61
  • Created
  • Last Reply

Top Posters In This Topic

if i had a car that ran 9 sec 1/4 mile, i wouldn't give a flying fcuk how quick it was on the street !! who cares ?

drag racing is from 0 to 400m, not from a green light to the end of the track, and a car that runs 9's on the track pulls around 220 to 240 km/h !!!! who the fcuk would do that on the street ?

"Drag Racing" is who gets to the 1/4 mile first....end of story

How fast you can do 1/4 mile is a different story.Munro has covered it pretty well

I've decided to see how the other side of drag racing lives and I'm entering my first bracket meet this Saturday at WSID. Lucky I don't have a 9 second car!!

Let's see what there is to this reaction time business :-)

Adrian

its whoever gets to the end first after the light drops..

what do you mean by "spooling up?" if you mean spooling up the turbo until the lights go green isn't that irrelevent as its your definitely not sitting there at idle *until* the green xmas tree light goes on in any car.

do you mean from idle revs or something?

:confused:

In any situation, whether at the strip or "elsewhere" you generally know you are about to be dragging and prepare things. Even if you're on a rolling start, your turbo would probably be "spooled up" anyhow.. so i can't see the situation where suddenly you both have to start at "idle" speed.

Ninja you mstne understand , when your at the drags you see turbo cars for examples VL's etc etc after the green light they sit at the lights getting some boost spooling up there turbo with antilag then launching on the perfect boost for launch on that car...id rather a car that can just go there and run a 9 like a GT-R and not sit on the lights for 6 years.... then take off.

launch assistance is another can of worms I think :mad:

If Leewah can show what his car is capable of with stock interior (is he still running the full interior?) and can drive to the track and do a 9 (even if it is a high 9) i think a new record will be set, at least in my eyes anyhow.

A half a second is obviously a lot longer amount of time than you realise.

Isn't he still half a second away from the 9?

Oh, and don't start quoting power figures at me... They mean nothing without timeslips :mad:

Adrian

Competition drag racing involves more than just timing from crossing the beams at the start, to getting to the finish line. Consistancy, reaction time etc are all just as important as ET. Especially in dial your own racing. Where RT and consistancy is pretty much everything.

Getting a bit of topic.............

A half a second is obviously a lot longer amount of time than you realise.

Isn't he still half a second away from the 9?

Oh, and don't start quoting power figures at me... They mean nothing without timeslips  

Adrian

When he got 10.47 or whatever it was, this was before the engine was rebuilt, and the happy gas added - and i think around 200rwkw less, and nearly 10 months ago now. So it should be capable of something a reasonable amount better. Im not sure of the exact configuration at the moment, or whether he even has plans to drag race it before sale. But yeah, hope he does :) But no, the power figure may not be a true indicator either.

I'm aware of the all the dimishing returns for gains, etc, etc when getting lower and lower into the 11 and 10sec bracket. Guess the NOS that makes it a little easier, but its either that or methanol by about that point.

Maybe in a position like this it would be better to run the time then claim the car has ran that time, as doing it and talking about it are 2 big different things, with the new power comes new problems ie gearbox and traction etc etc so just because someone has XXX more power then when they ran xxx doesn't automaticaly mean they will be that much quicker straight away

Brett

  • 2 weeks later...

Looks like of the guys (and girls?) around here would have only gone to a street meet or test and tune, and therefore are complaining about the cars spooling after the green light. However, as has been pointed out by one or two knowledgable people, there is a huge difference between an official drag meet and a street meet/test and tune.

The whole idea of a test and tune is just that - to test out different techniques, configurations and settings on a car. But when it comes to an offical drag event, then anyone who sits on the line still spooling after the green goes will invariably be the loser. I don't think anyone will argue on the contrary. As long as it covers the standing 1320ft between 9.000 and 9.999 seconds, then I don't see how anyone could deny a car's 9 second ET as being a 9 second ET. It is still a 9 second car at the track. Forget about the street.

As for reaction times, they actually do count. First past the line in heads up racing wins. Reaction time also affects bracket racing with reaction time affecting the final result.

Sure te VL's that sit there are spooling are 9sec cars, if there at a regular test & tune then they can afford to sit at the line as long as they like to get it to the required boost level there after to get the ultimate time.

But when it comes to proper real world competition drag racing under ANDRA regs then they would surely run on a pro tree.

For those that dont know what a pro tree is well thats where the VL lets say gets the a handicap start and gets the green light 1st while the lets say GTR has to wait a couple of secs before he would get the green so the VL would have its green light and would be spooling while the GTR is still waiting to go.

So in fact if that was the case and 1 of these 9sec vl's were racing something like leewahs GTR for instance on a pro tree then the handicap the VL would get would have it to its desired boost level for take off by the time the GTR owner gets the green so they would basically be takin off around the same time.

You have to remember all these 9sec VL's run very large non roller bearing turbo's with large exhaust housings so once they start catching onto the roller bearing turbo train then i think alot of these prolonged spooling times will be alot less if not non existent.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You have found the problem. The wire from the switch to the HB is shorted to earth. Now you have to physically find it and replace it. It won't be the switch, although following the steps above (and yes, where you ask, that is the light switch on the RHS of the binnacle) will rule it out for sure. Or not, if perhaps the switch has melted. But there's no route to earth inside the switch, so I can't see how it would.
    • I did read your post, a few times actually.    Done. Followed this step. [Negative probe should be on the cars chassis. Positive on the wire.]   Did this partially.. now that im reading this over, i only unplugged the LED lights. [Start as said above by unplugging everything (unplug the lights, and switches.] When you are talking about the switch, you're talking about the knob thing on the right side in the drivers seat right? If so, i need to take that apart?  [Now at the switch, there is a wire from the fuse, to the switch, so out your positive on that terminal. It should read open circuit. If it reads something, especially a stupid low value, the short is somewhere between the fuse and the switch.] At this point are you referring to the connector by the headlights?  [If that's fine, now put the positive probe on the wire that goes to the headlight (at the switch plug). If it reads stupid low, the fault is from the switch, to the headlight.] Did this. I can confirm that the LED lights aren't the issue [Another quick test, is take the whole LED light setup from the left, and plug it into the right side, does it still blow the fuse? If you put the right hand side led light setup on the left hand side wiring, does the left hand side wiring now blow?  If the blowing fuse swaps from right to left doing this, your LED lights are the issue.]
    • Hey was wondering if you ended up installing the R33 GTR speed sensor - I found one too and wanted to confirm it's a direct swap into the R34 6 speed?
    • After 23 years of owning a Skyline, finally had the latch go.  Followed this guide,  works like a dream again. Great Guide 👍
    • Hi all,   I’ve got the biggest lot of problems with my R33 GTS-T   It was a freshly rebuilt 25th anniversary RB25DET (plastic cas, neo cams) probably 6 years ago now   The engine was running so well but I fkd up badly and trusted someone I’d known for 10 years that was well known around Plazmaman for his welding and fab work. I added a lovely photo of some of his previous work. Not sure why my car was worked on by whoever did this shit     I’m normally someone who would never open myself up to something like this, I still can’t believe I did it. Trusting him literally fkd it all up for me. Everything has been a struggle, like it’s almost been 6 years that’s how much I’ve just on and off been trying to work it all out.    All I wanted was a car that danced down low, like full boost from around 3~3500rpm to redline, don’t really care what power it puts down (if it ever does) but I just wanted it to be quick to get on it.    He recommended the turbo to get, I picked Hypergear but he told me to get the front 4” with a T4 and 0.68 rear housing.    I was expecting all these beautiful welds, tidy fab work and paid for it to be ready to go to a tuner when I got it back.    I got a car back that was an absolute mess, I actually couldn’t believe it was my car anymore. I don’t think you could even call what he did welds, they’re disgusting.    So I stripped everything he touched off it and with every bolt I loosened it just got worse and worse.    I covered it and literally built and finished another car in the meantime but now it’s getting to the point where I really want my Skyline back.   Its a struggle because I paid him to do all this shit because I didn’t know how to and now I’ve had to try and figure it all out omg    Please excuse the bird shit horrible welds, I’ve got my show pony car and am so beyond dealing with this car I don’t even really care at this point.    If someone told me about what he did to my car I wouldn’t have believed them but it happened to me. It was unbelievable. He went missing, my car went missing, it came back missing parts, the straight af chassis rails bore the scars of being dragged up a trailer backwards, even the sandwich plate was bent. Everything was leaking and open to whatever fell into it, rounded off/ missing bolts, power steering oil and coolant everywhere, no gaskets, parts stolen off it, even managed to damage the sump pan.   Promised me he’d finish the car, knew what it meant to me, I paid him thousands and thousands just for him to trash it. He told me he was fully licensed and insured, come to find out he’d cancelled his ABN, so obviously no insurance. I had laid up insurance on the car and would’ve been covered but I was scared they would’ve written it off or because the business was no longer trading I’d still be liable.    He was supposed to:  New fully custom mild steam pipe exhaust manifold with turbo location moved from factory position to high forward mount. (I don’t know if it is a mild steam pipe, I’ve got a funny feeling the waste gate isn’t in a very good position and I don’t think the outlets off each cylinder are equal) 4” custom stainless steel dump with external gate (he re-plumbed it) Cut and shut OEM intake manifold with throttle reposition (I ended up doing the throttle reposition) Box in pod filter (left out) New 100cel catalytic converter (pretty sure it’s there but unsure if it’s 100cel) Front mount intercooler piping fabricated to suit (all smashed up and rusty holes where he was supposed to make it look standard where fmic piping passes through. I don’t even think my front bar is going to fit 🙄) Custom 5” intake pipe from pod to turbo (didn’t come with it so had to do something to make it work with the Z32 afm)   Engine: Full cylinder head service & machining  Brand new valves Precision upgraded spring kit Engine block honed New bearings  New piston rings  New ARP conrod bolt kit New ARP head studs Cometic head gasket VRS kit   ATR43SS2 ball bearing turbo 0.68 rear housing  Turbosmart 45mm external wastegate (got delivered to the fab bloke, I’ve got no idea what spring is in it, I’m assuming the one that came pre installed) Walbro 260 fuel pump  Nismo 740cc injectors (tested to 880) Spitfire coil packs GCG FMIC RB25DET manual 5 speed 4:11 rear diff   I’ve got an Apexi Power FC in it atm, I was hoping to just get it to operating temp to make sure everything was okay before towing to a tuner but it’s over-fuelling too much. I don’t think that’s going to happen so i think I’m going to get either a Link G4 or Haltech for it. What do you guys recommend? I can’t work out the power FC so just gonna give up on that one     It’s got an exhaust leak coming from somewhere I can’t see 🙄    The fuel pressure was steady but now it like drops from 40 to 20psi randomly (noticed this yesterday)    I’ll attach pics of the shit he put on my car and the engine bay now as it sits    I really just need some help, I need a tuner in Sydney I can trust, I’d like to be with the car while it’s being tuned if possible, I know it looks terrible but unfortunately I’ve just got to put up with it for now and fix the cosmetic stuff later   Do you guys think the manifolds are going to be okay? Or do I throw the exhaust manifold and try again?   I don’t even think these combinations are going to work tbh   I know everything I fitted was rated to be able to take at least 400kW but most rated higher    If you’ve gotten this far I really really appreciate it 🙏 I don’t mind if you trash me or the car, I made a rookie error and f**k I’ve paid for it. As you’ll see 🙄  
×
×
  • Create New...