Info On Making My S1 Man

[whitenight27]

ok and with the hand brake braket do i need the bit of the r33 tunnel that the handbrake its self bolts to?

has any 1 got a pic of what u need.

i have all the handbrake and cable but i not know if the guy i getting it off knows what i meen by the braket

[4bidn1]

Ill send ya a pm

[whitenight27]

has any 1 made a center bit for the center of the auto console to make it man?

[KiwiRS4T]

Yep just get out the trusty hacksaw or whatever and "modify" the auto console after the gear lever and handbrake are installed and get some R33 boots for the gear lever and handbrake.

[whitenight27]

dose any 1 know if 32gtr calipers and disks will fit on my s1 c34?

[pipster11]

dose any 1 know if 32gtr calipers and disks will fit on my s1 c34?

Should be spot on but pull a caliper bolt out and measure the diameter of the threaded section

It should be 12mm ish which is r32/r33

If its 14mm ish then you need r34 stuff

Most s1's are 12mm but some aren't

[whitenight27]

ok good info t know.

would u happen to know where i can get ( besides Nissan ) rear rotors and hubs?

[pipster11]

What did you need the hubs for? Just try your nearest jap wreckers or Google stagea parts or try the classifieds at the top of this sub-forum

[whitenight27]

Need because the rear bearings need replacing and Nissan told me they come in a sealed hub.

[pipster11]

http://www.skylinesaustralia.com/forums/topic/112077-r33-rear-wheel-bearing-replacement/

[whitenight27]

u would not happen to know where i can get some rear disks for a 97 s1 rs4? i know about nissan but there 130 each

[pipster11]

http://www.japaneseimportspares.com.au/itemdetails/35197

Or check the brake thread at the top if this section for part numbers

Or even try eBay?

[whitenight27]

Will try them. Yer looked on eBay only could fine m35 disks