Rb25 Series 1 Tps On Series 2 Wiring

[SYK-200]

Ok, so me and my brother built a rb25 180sx, we got the front facing plenum and the larger throttle body, its been a few months now without driving the car because their are MANY problems with it and i just realised now we got the series 1 TPS sensor because the throttle body only took the s1 TPS, so im just wondering which wires go where, on the s2 engine loom their is yellow/black...red/blue......blue/black and on the TPS sensor their is blue, white and pink? so any guide to that will help, iv'e looked everywhere and cant find anything on s1 tps -> s2 wiring.

another thing is this: i grabbed a multimeter and measured the volts the wiring is putting off

their should be

yellow/black -> 5volt

blue/black -> ground

red/blue -> TPS signal, BUT im reading like 2.5volts from this? with nothing connected, so its like the ECU is SENDING this wire a voltage? wat the boo!

help would definitely move this purposely built drifter into actually drifting, we finished it last year august, havnt even got a chance to run the engine in yet

[T04GTR]

the wire positioning is the same, regardless of colour.

[SYK-200]

alright thanks alot, thats 1 less problem to worry about lol!

[Gameboy]

the wire positioning is the same, regardless of colour.

Can anyone else confirm? Im doing the same thing. Series 1 TPS on Series 2 wiring.

[KiwiRS4T]

Easiest solution use the stock throttle body and tps.