Jump to content
SAU Community

Recommended Posts

I've been running these Federal 595 SS tyres for a while on my R32 GTR. In the dry they aren't too bad, although they aren't amazing, but in the wet I feel like I'm driving on ice. Even minor acceleration around a round about and I'm understeering towards the gutter. The back end can be a little skittish too, but that is quickly corrected by the 4wd sending power to the front, which then makes it under steer like crazy. The tyres it had on previously were no name chinese tyres, so I'm not really sure if I'm expecting too much of it. I plan to take it in for a wheel alignment this week.

Has anyone else had experience with these tyres and found them ghastly?

Would the Kumho KU31 be any better?

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

nothing wrong with 595ss, unless you drive like a tool they should be totally fine for driving around streets

sounds like your wheel alignment to be honest, they have been fine for me in the wet

havent seen any difference between them and the bridgestone RE001`s i had on my old car (cost a lot more than $20-$30 extra)

the people with lots of money to burn will tell you to spend a lot, but in reality they are as good or better than lot of more expensive brand tyres

you probably need some more camber if youre understeering

I've got no problem spending an extra $20-30 a corner, but it is a bit stupid to say that without giving some examples of better tires for that amount of money. I'm not going to go a spend a few hundred per corner, I don't drive my car hard enough to warrant it. It is my daily driver to and from work. I just expect to be able to drive around a round about without heading for the gutter even at very low speeds. It has been a problem since them were put on the car, perhaps the tyre shop hasn't been doing a very good job at wheel alignments.

Yeah they must have done something with the wheel alignment, when i say light acceleration makes it understeer, I'm talking abou the slightest pressure on the pedal. Well I'll get it into a proper suspension shop and get them to check it out. Next time I'll spend a little more on the tyres.

595ss/KU31 - same boat really. Both are not a decent performance tyre so you'll be making compromises.

Depends what you want, and what your budget is.

You would always drive slower in the wet around round-a-bouts, most people do that.

Way i see it if you cant control a car driving normally on tge street with average tyres you shouldnt have a licencse its not like your tsking at 200kms on the street snd in the wet shoild always be extra cautious. Btw im not personally aiming this at OP saying this is hes case just generslly saying.

Adjusting just camber , will help a little !

but you should be maxing the toe as well it should corner unbelievably but will cause tyre wear , but its well worth it ,

i run Ventus Hankook RS -3 tyre

Way i see it if you cant control a car driving normally on tge street with average tyres you shouldnt have a licencse its not like your tsking at 200kms on the street snd in the wet shoild always be extra cautious. Btw im not personally aiming this at OP saying this is hes case just generslly saying.

What do you do when some half drunk ass hole steps out in front of you, or a car pulls out infront of you?

That the way I see it

What do you do when some half drunk ass hole steps out in front of you, or a car pulls out infront of you?

That the way I see it

Unless your speeding or doing something wrong you shouldn't really need special expensive tyres to stop in time.

im running them now, they're ok for $120 fitted in 235/40/18.

experience some minor understeer in the wet, might be related to my wheel alignment tho as it had the same feeling with toyo proxes 4 as well.

in the dry they are decent.

I'm running -3.5 front and -2 rear camber, Hankook ventus RS 3, 255/40 17.

I have no understeer on the street wet or dry.

Cheap hard tyres are fine for shopping trolleys or doing skids.

Tyres cost $125 a piece from tire rack.$730 delivered.

Why do people buy sporty style cars and then go pov on the most important part.

595SS's aren't the greatest but they're alright bang-for-buck, I have run them as daily tyres on all my cars for a few years and have never had issues like the OP has mentioned.. even in my stiffly sprung, low, 2-way'd, 3L'd R32 GTSt.. even in the 2t Wagoon of Hillariousness, no crazy understeer issues :blink:

What's up with your alignment settings OP?

Unless your speeding or doing something wrong you shouldn't really need special expensive tyres to stop in time.

Whut? :blink:

I agree with Zebra. I run Toyo Proxes R1Rs because who knows what might happen no matter how awesome I am.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks everyone for the replies and suggestions. Got the seats out (hoping I could find some existing grommets but no such luck). By tapping and measuring etc. I could figure out where I could drill through if needed. But first I borrowed an inspection camera and managed to go through factory holes in the chassis rail and could see that the captive nut was holding steady which is why it could retighten. So it was indeed a stripped section of thread, so I applied downforce by levering the bolt head with a screwdriver and went slowly back and forth until it came out. Camera helped a lot cos I could monitor that the captive nut was holding tight. Now I just have one very seized main subframe nut to tackle 😅
    • BOVs do have a purpose, if you ever log pressure before and after the throttle body, you will see a spike pre throttle on lift off from a WOT condition. Enough to bend throttle blades / damage e-throttle motors or simple assist in blowing off cooler pipes. FWIW, the above on really applies to those running at least 2 bar of boost. OP shouldn't have an issue, on the other hand, here are some videos of my shit box over a decade ago with some succulent dose with the airbox on and off. That shit box is unrecognisable these days 🫠    
    • I've tried all different combinations of BOVs/ no BOV and stock bypass valves over the years, on gear changes the stock bypass valve seems to get the car back on boost quicker because in part the turbos wheel speed isn't being slowed down by reversion, although they have issues holding boost much over the stock setting. Most aftermarket BOVs you can adjust the spring, tighter will make it open later and close sooner, but in my experience it'll cause a bit of flutter at low load/rpm anyway. I've also got some input into this whole no bov causing turbo wear, never had an issue on any on my turbos HOWEVER, I got my R33 GTST with 200k kms on it, with from what I can see still has the original turbo, no lateral shaft play but has about 4-5mm of play in and out which to me seems like a worn thrust bearing from years (100-150k kms?) of turbo flutter running no bov, so maybe there is some truth to it in the long run. But that'll never stop me loving the Stutututu while I have the car.   OP just wants to know if he can run a atmo vented BOV with no major issues and the answer is YES, plenty of people do it, there's no harm in installing it and seeing how it runs before spending $$$ on an aftermarket ecu, last time I bought a Nistune it was $2400 for install and a tune , unsure of todays prices but you get me. Crazy money to spend just to fix the minor inconvenience of stalling that can be overcome by letting the revs come down to near idle before putting the clutch in or a little bit of throttle to avoid it. You're better off leaving the ecu and tune for after a bigger turbo/injectors have been installed to take full advantage of the tune and get your moneys worth.   Let OP have his Whoosh sound without trying to break his bank haha
    • I see you missed the rest of the conversation where they have benefits, but nothing to do with avoiding breaking turbos, which is what the aftermarket BOV made all the fan boys, tuners, and modders believe was the only purpose for them...
    • But they do so for the other reasons to have a compressor bypass. It's in the name.
×
×
  • Create New...