Jump to content
SAU Community

Recommended Posts

Just like to know what turbos you people have in your skylines? What do you think is the best low-mount turbo for a rb25det. I have been told the best for a street application would be the HKS GT2535. What are your oppinions? Does this turbo bolt straight on, if not what do i have to do to get it in? Looking forward to your reply's. Thanks!!!

Link to comment
https://www.sau.com.au/forums/topic/39741-aftermarket-turbos/
Share on other sites

hrmm, i think either one is sufficient for the amount of power you want to make... i would consult a turbo specialist on what the best turbo set up for your price range is.

i am just talking from experience with my friends Hiflowed T3, that worked a treat.

Hopefully someone with a 2535 will comment on that turbo and its advantages! =)

I have an HKS 2535. Just got it put on. Had fuelling problems when i went to the dyno so couldn't wind past 7psi but was getting 180rwkw at that boost level. Have just received my adjustable fuel pressure regulator and expecting a Z32 AFM and will post results when i get them. I have wound the boost up to 1.1 bar and it hits that by 3,300 rpm and pulls very nicely indeed. I hit boost cut at 1.15 bar at about 4,000rpm the other day which is my airflow meter maxing out at 5v which on an R33 happens about 220rwkw so this turbo should easily see you to your desired power level.

As for installation, it bolts straight on to your exhaust manifold, dump pipe, AFM pipe and with the supplied elbow, to your intercooler pipe too. I got the GT Sports Turbine Kit which came with braided hose for the oil line and new replacement piping for the water lines. Hope that helps.

oh, you wanted mods too...

When I finally get my power run again I will have:

Trust FMIC, Z32 AFM, Bosch 910 fuel pump, Nismo adjustable FPR, full exhaust, Trust Ex Cam Gear, S-AFCII, Blitz EBC and rebuilt engine with forged pistons.

you should be fine, so long as your engine has sufficient compression and when your running 12psi it isnt leaning out/detonating etc...

invest in a dyno tune from somewhere that is renouned for tuning properly.

Reliability is the key!

Nothing sh1ts me more than when someone tells me they have 200+ rwkw and have their standard injectors maxed out etc etc. Thats just not cricket.

Reliability is the key!

Nothing sh1ts me more than when someone tells me they have 200+ rwkw and have their standard injectors maxed out etc etc.  Thats just not cricket.

Exactly!!! I will have a power FC so as far as that goes it can be tuned accordingly. I hate when i go to shops (no names) and the guys there tell me that i can get easily 270 rwkw from my standard engine without problems. I think that is total crap! Can do it but it will probably last about 2 months or so, then the problems will arise. Anyone here have that kind of power with standard internals? Just like to hear about it?

i am attempting to put on a t3/t4-super t 70 on mine all i can say it is ***ing huge 1700 it cost brand newcop a look at the specs.....shaft and wheel trim64.5 mm -compressor wheel super70 60.5mm -turbine housinga/r84.-compressor housinga/rratio.70... supposed to be capable of 650 hp can any one who knows what they are doing tell me the go and what mods/ lag ect i will expect

I hate when i go to shops (no names) and the guys there tell me that i can get easily 270 rwkw from my standard engine without problems. I think that is total crap! Can do it but it will probably last about 2 months or so, then the problems will arise. Anyone here have that kind of power with standard internals? Just like to hear about it?

Your engine will last with 270rwkw on standard internals, I know of several cars that have lasted over 6mths each after being very heavily murdered with much more than 270rwkw. It all depends on your tune :rant:

Guest INASNT
Your engine will last with 270rwkw on standard internals, I know of several cars that have lasted over 6mths each after being very heavily murdered with much more than 270rwkw. It all depends on your tune :)

It depends on the tune and how u drive. If u drive like a tool all the time at full throttle then ur engine wont live long.

Mine has lived with over 300rwkw high boost and 260rwkw low boost for about 2 months now without any problems.

Fuel seems to be the problem IMHO. Alot of people try and stretch the stock injectors to places they just werent meant to go. All that I know of who upgrade the injectors and dont chase every last kw, have had no dramas.

Personally I wouldnt really want to chance it (well I didnt chance it). If you upgrade the injectors as you fit a bigger turbo you will be safe - with a good tune. Cheaper than a rebuild - infact cheaper than a set of forgies:)

I have over 300 in a daily driven RB25, running over 20psi no problems - stock internals. the JMS R33 had over 300rwkw with stock bottom end too, and that gets caned - still going strong.

I want to do everything properly, no short cuts. What would be the best size injectors for this application? Where do you suggest to get the car tuned at? I heard that Croydon Racing is the best but they charge an arm and a leg! I think it was like $700! Any other good places?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oh, that's grim. Something bad has been happening there.
    • Put an endoscope down the hole and saw this. Not quite all around the bore but a good 60% at least. Chin to the chest and towards further disappointments I guess.
    • 2 does "sort of" applies, maybe......but looking at what parts would be needed for the swap to get engineered, registered, and insured, and basically that's everything under the car, the modifications the make it legal would be problematic and horrendously expensive, all for a street car that just cruises around and hits a few twisty roads on the weekends Also, from looking at the NSW rules and Regs, with all modifications that is required just to make the car safe and not twist itself to pieces, and then actually get registered for street use, may still be impossible nowadays As for 1, when you add in a fresh engine, fresh transmission, rear cradle and diff, tailshaft, suspension, brakes, cooling, and all the other fabrication required, your probably looking at up to $100k to do it right, all for a 20 year old MX5 that is over engineered and you would never be able to actually use the power it has on the street, much like your beastie, which I love, but you actually track that thing and can use all of its powers in anger, in a safe environment  Hell, the old Bogan Cruise Ship had more power than I could use on the street, and in hindsight, I went a bit silly on that thing, it didn't really need the 500hp it had for what I actually used the car for, it was fun, but basically unusable on the street if you value your licence  As for cams, yeah, I'll probably book it in for them to get installed and tuned soonish, like next month after MX5 Mania are back at work....... and yes, I've already sent a email to bin the turbo quote and quote instead to install cams and a new Fluidampr balancer that will suit the 2.5 better than the OEM 2.0 balancer that is swapped over for the 2.5 install, as the balancer needs to get pulled to time the cams it's a while your in there sort of thing I did think a bit about flex fuel for a laugh, but being na, and no where really around locally anymore to get E85, I've binned that idea, so no sweet sweet corn smells are set for the car I wish E85 was more of a standard fuel, it's better for the environment, better for tuning, plus that sweet sweet smell we all love As for fitting in the family, that's not needed, as everyone in the family already owns a car that can seat 5 humans comfortably enough, the MX5 is "my toy" As for buying a car that is already built, nah, I would rather pick and choose my parts, I enjoy the process, and in the big picture, the additional cost is well worth the enjoyment, and the occasional frustration, I get out of doing it, albeit with other people spinning the spanners, and me, just paying the invoice 🤣
    • Excuse me, but 2) does apply 1) Would also apply if you consider how much is spent in the alternatives. Also there's the option of 3), buy one pre-built that you can put your family in (it's me, it's my car)   That said, I went on a ~500km drive the other day. I didn't use anything more adventurous than 3rd/4th gear at about ~3000RPM and 50% throttle and I was going as fast as anyone has any sense doing on a public road, with enough grip to the point where I didn't want to go any faster. I was obviously under the limit of the current car etc etc. MX5 with 2.5 N/A to achieve the same speed would be more fun for any road scenario. Maybe consider cams. I wouldn't boost it. The use case is just not there and it won't actually make the car more enjoyable unless you really do plan on wringing gears from 1st to 3rd (at least) at 100% WOT on a public road to 150+kmh.
    • Great if: 1. You had all of the money for everything else that is required  2. Lived in a country where you could actually do this and drive it legally on the road Sadly, neither applies to me As for the turbo, I am having second thoughts, mainly for engineering/registration legality reasons and insurance  Not saying I've finished doing stupid things that I probably should do to the MX5, but boost, and V8 engine swaps isn't on the cards Strange, but true 
×
×
  • Create New...