Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

intercooler hose.. can mms u a pic if u like.. pm me your number

it goes just under the airbox, basically from engine bay to the pipe that comes off the passenger side of the intercooler

intercooler hose.. can mms u a pic if u like.. pm me your number

it goes just under the airbox, basically from engine bay to the pipe that comes off the passenger side of the intercooler

number is on the front post 0422646961and yes i have that part :)

Will hafta pass on the wheels sorry. Ill check back to see if you have them in a few weeks.

No problems :)

u wouldn't happen to have the cold air intake pipe or snorkel piece off the air box would u?

Sorry it has a blitz pod filter and i never got the stock airbox :(

Hey bud, what is the condition of the steering wheel and auto gear lever? Is the auto surround still for sale?

post to 4558

Steering wheels is in ok condition i have a cover on it and have since i owned the car, same with the auto gear lever in ok condition, the surround around the auto lever your talking about ? i still have it currently, and yes will post all parts :)

Hey bud i rang you before, just to clarify what im chasing.

Currently the 34 my misses is picking up tomorrow has this configuration...

post-30257-0-28435400-1335691872_thumb.jpg

Chasing the bits to change to this configuration...

post-30257-0-53062800-1335691936_thumb.jpg

Can you PM me a pricing for those three parts.

Ill check back for the pics of the wheel and the gear selector.

Cheers bud.

Edited by RB25DETC33

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • FWIW the depth of the groove in the rubber pad is not super essential, the blocks are rubber and squish a bit. If you are worried an angle grinder will make a deeper groove quick smart
    • I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
×
×
  • Create New...