Jump to content
SAU Community

Tial Qr Bov

jobo
 Share

Recommended Posts

jobo Apprentice

jobo

Posted
Posted

This bov will handle serious power, is made in the USA and is quality built. Designed to recirculate (plumb back) it will vent just about any boost level turbo combination you can throw at it. Comes with a brand new generic flange in case you dont already have a vband flange. Comes with 2 springs depending on your vac level. I great performance part only been ony car for a few short months.

$220.

Why buy a new one for 400 when you can get the same deal for almost half price.

If you don't much about tial products, have a look ar

Link to comment
https://www.sau.com.au/forums/topic/398228-tial-qr-bov/
Share on other sites
Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Shockabsorber 101

      By GTSBoy · Posted

      KYBs are typically twin tube, putting them in the lower tier of desireability. Do you just want to replace worn out ones for the lowest cost? I mean, you wouldn't just replace one end of a car, if the rears are a similar age to the fronts, then they are probably nowhere near what they should be, and likely won't be great against brand new fronts. So, to spend ~$800 on 2nd tier dampers, when you could get a decent set of MCA coilovers for <$4k.....? As to the strut tops. 1st up, the Sparesbox site specifically tells you that they are not correct for an R33. Beyond that, why do you think you need them?
    • Dose Pipe Sutututu
      High temp brake fluid?

      By Dose Pipe Sutututu · Posted

      That's not very Toyota of the Toyota!
    • benl1981
      Shockabsorber 101

      By benl1981 · Posted

      Bringing an old thread back to life Looking to put some new front shocks in the r33Gtst and the KYB still look ok for a road car. Unless there are any other options aroind that price $200 a shock?  I’d like to replace the strut tops also, is this the correct KYB no. For the strut top, KSM7124?  https://www.sparesbox.com.au/products/kyb-strut-top-mount-ksm7124?srsltid=AfmBOoq-HDru8wSlLnQrhU9gCw_uYdKg8gUQzONY-EQOdnI5iXOWEUjY 341287 appears to be the front KYB shocks part no.  thanks all   
    • MBS206
      High temp brake fluid?

      By MBS206 · Posted

      LandCruiser used to get a fluid flush every 12 to 18 months.   Only because it was about that often the electric motor on the master for brake assist kept dieing and needing to come off.
    • Murray_Calavera
      High temp brake fluid?

      By Murray_Calavera · Posted

      lol I thought I was bad 
×
×
  • Create New...