Jump to content
SAU Community

Recommended Posts

R32 interior sale

Passenger door card 20

L and R a piller trims 5 each

Bottom door trim with skyline on it L and R 5 each

Boot trim L and R side and boot carpet 10 each

Rear trim L and R 10 each

Climate control unit missing a button 15

Roof of glove box 5

Glove box 20

Metal bit that glove box hinges off 5

Bottom drivers dash bit 10 dash fuse box flap 5

Air induction thing under head light 10

Rear window bottom trim 5

Wiper arm with new wiper 10

Passenger door seal 10

Center dash surround 10

Chrome monza pod filter cover will make u win auto salon or apperntly pass a roady 1 dollar

L and R kick panel 10 each

Handbrake cover little worn no rips 5

6 bolt half shafts 10 each

Cover between glove box and passenger door 10 

Centre air vent 20

33 centre console, may fit 32? 25

33 rear seat will fit 32 10 top 10 bottom

Manual tyre changer missing tyre lever 20

0430505810 DO NOT TXT phones cut off u will not get a reply, located emerald or montrose during business hours

Link to comment
https://www.sau.com.au/forums/topic/399937-r32-interior-bits/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have one and it was at ~43.5PSI.
    • Put a pressure gauge on the fuel rail.
    • I've uploaded logs / the current map to Gdrive if anyone has any ideas. https://drive.google.com/drive/folders/1FPnr22Z-EilG7tYdHSi0Qb07P2jfFLKV?usp=sharing
    • I'm running a Haltech Platinum Pro with the stock map for the RB20DET + tweaks for my build. When I started it this morning, the IAT was at 32F/0C (Outside temp was ~42F) and the AFRs went off the scale for my AEM gauge. I let it run for ~30 seconds then turned it off. I then did a smoke test, by hooking into a vacuum line directly behind the throttle body, and confirmed there was no leaks ( i let the smoke tester run for ~5 minutes / confirmed it was generating smoke before hand ). I then started the car again, after fixing a power steering leak.... and it seemed to be happy for ~30 seconds (was at ~11/12), but then seemingly shot back up to ~18 again. I then let the car run for a few minutes, thinking this was just cold start related, but the AFRs never came back down. I didn't let the car fully warm up, so maybe this makes sense, but I'm not sure what to do? The AFRs, when I last ran it, were normal, but because of personal reasons I haven't been able to break in the car. It was rebuilt last year. Engine / Mod list: Supertec pistons Spool rods Kelford 270 cams and Springs Stock crank Deatschwerks 900cc injectors Walbro 255 (Wired directly to the battery relocated in the trunk) NKG Audi R8 Coil packs + Conversion Harnesses from Wiring Specialties Holset HY35 turbo Haltech Platinum Pro ECU Haltech boost controller (wired in for high boost RB25 Neo transmission + needed bits for the speedo to work  
×
×
  • Create New...