Jump to content
SAU Community

Recommended Posts

AS STATED SHOW SOME INTEREST AND I WILL STRIP BUT PREFER WHOLE CAR GONE !

-ALL SUSPENSION UNTOUCHED JUST BODY DAMAGE !

-Had the thing for 6 months only been on the road for 2 weeks. Under went a FULL RWC at the pits not a dodgy mechanic. Has new bushes pretty much every where only nolathane, new upper inner ball joints, 4 rack ends, tie rods, wheel aligned 2 weeks ago and has 4 almost brand new tyres. Passed inspection no worries (made sure it was perfect)

-Crashed in the front pushed rad support back into engine sooo headlight, front bar, intercooler, rad support maybe radiator (still holding water and doesnt look bent) bonnet. thats what i can list as damaged off the top of my head

-rb20det 4wd motor. Runs well and goes very well has a RB25 turbo with steel wheel 20 acutator bolted to it

-17" sparco wheels 8" front 9" up front lowered with RSR springs and upgraded struts, m spec side skirts

-Did have FMIC but shes finished, Pod filter, have an adjustable bov but has blocked stock one for flutters :P

-obviously has the attessa system and it has a torque split controller

-3inch turbo back blitz exhaust, trust dump pipe

-650hp fuel pump, stock computer with assumming stock tune. pulls hard though for a lil 20

So as stated the suspension has been untouched. Buy something like this for 600 http://www.ebay.com....#ht_2084wt_1270

and then you would have a rare gts4 skyline front quarter panels are un damaged . or just pull it back off the be;ts and have no front bar, bonnet and lights. Im thinking of just this my self if i can find a cheap panel beater but if someone else wants it they are welcome to it. would make a shibby track/drift car

the car is a repairable write off any questions call 0459302735

Price for full car 2800...2100 if wheels are supplied. Front diff is a bit noisy when ran in 50 50 config but not in the attessa setup. 600 for both

you in melbourne? if not 3064 is my postcode what postage costs am i looking at?

Edited by ZILLR

Not in melbourne about 5hrs away could possibly meet halfway if i decide to strip if an extra 100 is given. postage id assume would be about 250

could do with a paint id say but yea there fine i would post. as stated may not strip just seeing if there is interest. will strip if motor/box is wanted

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Do the following first and get back to us. - Clean and verify your IACV - Verify for vacuum leaks/post MAF leaks. (Pressure test is the best and cheapest way) - Do you have a BOV with stock ecu/MAF? If so, remove it.     
    • Hey all, The skyline I have is stalling when the engine is at normal operating temp.  When starting it while it is cold, it'll run just fine.  I have replaced the battery (bad cell), I have replaced the fuel pump, fuel filter and clean the MAF sensor.  Any other suggestions?
    • Thanks for all the information on this.  I tried ordering the parts from Amayama website and all 3 Solenoids are discontinued and not available.  Does anyone have any other websites to suggest that I could find the parts?   Separate issue-- I will start a new thread, but basically the vehicle is stalling when warmed up.
    • It's unfortunate what Tomei USA has done to Tomei's name in general. I'm very weary of ordering parts from them now. I only order direct from a Japanse source (e.g Nengun). At least their logos are different, so you end up knowing what you have. 
    • Update Issues 5 (plus #4) - 10 After making a claim about issue #4's missing part, DeAgostini Japan sent a whole new issue #4 and it arrived about 2 weeks after that. That was back in early March. It took another 4 weeks to receive issues 5 - 13 though. This update is for issues 5 - 10. Ove the 5 issues the front left suspension and most of the engine have been completed. The quality of the castings and fit of the parts is quite good, it seems better than DeAgostini's BNR34 Skyline GT-R from the Fast & Furious 2 movie, which (to me anyway) doesn't seem to have as tight tolerances or quite as accurate castings.  Each issue has a lot of info about the 1989 - 1993 Skyline range and other Nissan models from that era, but the focus is on the BNR32 Skyline GT-R Nismo and the various racing it did in Japan, Europe (Spa 24hrs) and of course Australia. I've included some text translated with Google Lens in some photos and will add to them if there's anything worth including. 
×
×
  • Create New...