Jump to content
SAU Community

Recommended Posts

nah its not a rag lol, theres other crystallized looking stuff of the same colour in the thermostat housing, which is why i thought gasket would be f**ked, could it be pink coolant sludge?

I know when I worked for ford a lot of the older models had that pink coolant crap and leaks did chrystalize like that... If its the same as the stuff on your thermostat housing and the coolant is was pink then you've probably answered your own question... I'd be investigating further as its hard to guess from a single pic... What did the intake gasket look like?

Ow wow, now i am on a PC that pic looks gross! :P But if there is pink in the cooling system then its probably coolant, and if there is coolant there its probably not good news....

This looks alot like an anti corrosion and coolant additive called Nalco which we use on all our Caterpillar and other large and small gas engine that I work on. When it leaks it crystalises very similar to this and is a very similar funky pink colour.

If you get the dosage wrong it can destroy waterpump seals from memory its ratio is around 1litre of treatment per 50 litres of water, Most of the engine I work on hold around 1000litres of coolant so a 20litre drum does it just fine. When mixed correctly though it should be a very pale pink colour almost barely visible.

Maybe its isn't the same stuff thats in your engine but as i said it looks very similar colour and seems to cystalise similar to it.Perhaps pull off the water pump to see if there are any other traces of it in there.

Good luck

Edited by rb2534

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • How old is the battery, it's more likely your battery is on its way out.
    • I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...