Jump to content
SAU Community

Recommended Posts

Just found out that the law doesn't require me to have a cat. so I've decided to get some pipe and make a few flanges. Anything to look out for when i'm doing this? i know there's currently a temp sensor but i just want to cable tie it out of the way for now.

Also, will this give the car a better sound? as it already has a nismo 3" exhaust. is the cat holding me back from a better note?

Cheers

http://www.youtube.com/watch?v=bsIrz_LaHdo

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/
Share on other sites

Pretty sure the law says you need a cat !! If the car came from oem that way , your not going to feel a lot of power over a hiflow car , only noise that makes it sound faster

A decrease if your cat expands pipe goes from 2.5 ,3 to 5in the air turbulence actually makes less power

Plus smells like hell to idle

The fine is huge if your not running a cat or shop removes it for street use

After running no cat on NA rx7 for 11 yrs except for 15 min california style emissions test only to remove it again , on that full race motor i noticed it a lot but the factory intakes etc had to be put back on to pass too and a bottle of emmisions pass junk poured into the tank for the test on bridgeport motor

Its not worth it buy a 100cell for 200 bucks which is sorta legal anyway

Can be drone at speed which is super annoying

My 2 c

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6471385
Share on other sites

I gutted my 3" cat and felt and heard no difference. Kakimoto 3" exhaust.

But there was the occasional bang of a back fire changing gears or just backing off the accelerator.

And yeah I'm pretty sure by law you need to run a cat. I think if the car is pre '85 (or somewhere around there) then no hotdog or cat required, just mufflers.

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6471431
Share on other sites

Carbon 34,

OP is from NZ - cats are not a requirement there, I'm lead to believe.

I thought the same thing, but I believe this has been revised.

http://www.transport.govt.nz/legislation/Vehicle-Emissions-Questions-and-Answers/

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6472514
Share on other sites

Cheers for the input, the car is registered as a special interest vehicle (used to exempt cars from NZ regulations on frontal impact and emissions) which the R32 GTR classes as.

The car sounds quite droney already and it does occasionally spit when on the overrun and changing gears, see what the story is on the weekend.

Link to comment
https://www.sau.com.au/forums/topic/406140-de-cat-advice/#findComment-6472518
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, but it's not as easy as pulling a fuse on anything other than an R32. There's a routine you have to do, involving disconnecting a loom plug and bleeding down the preload.
    • A question for tuning awd, is it possible to disable the AWD? The stagea is an EA/T AWD, Toshi had said on a GTR, he was able to disable it and make it 2wd. Just wanted to double check if this was possible
    • Whoa, that's a name I've not see for a long time! Sorry to hear about the engine / turbo damage.  Fwiw with any engine problems it often really a case of just seeing what happens when it's apart, ymmv - I wouldn't rule out the possibility that the damage isn't even from the turbo failure, or possibly from a combination.  The airflow between cylinders isn't dead even, injectors can go off over time as well, with the turbos overboosting if you didn't have upgraded fuel system there could have possibly been a bit of leaning out - stock triggering is often a bit unreliable by this age too.  Basically its an old engine and a few things could have been going on, and you won't know how much work is needed until the engine is apart.  
    • I'm just shocked there's a euro driver on our roads who is thinking of other road users and not attempting to blind everyone. I wonder if Prank uses his indicator too...
    • Its hard to tell really. The Q50 owner's forum talks about it a lot and has quite a few people directly affected, but no idea what % of cars sold actually had the block replaced. Also, there seem to be 2 distinct issues which both get diagnosed by Infiniti as requiring a block replacement (no wonder they are going broke) 1. "Porous block" where coolant mixes with oil through thin or poorly cast parts of the block 2. Head coolant gallery plugs not sealing. If I was noticing engine coolant loss I'd start with cooling system pressure test (as always) and then I'd pull the cam covers and reseal the coolant gallery plugs on both side before worrying about a potentially porous block.  If neither of those did the trick it would be put in a second hand engine out of japan; I haven't checked pricing but I'm sure there are plenty around by now as they've been in production 10+ years
×
×
  • Create New...