Jump to content
SAU Community

Recommended Posts

Ok dudes i know i have some sort of issue with the car missing at around 4-5000rpm, which after much messin around we figure its gong to be coil packs.

We ran my car up on the dyno at my mates wshop on the weekend and ony made 134rwhp this was just over 4000 rpm

the car is r33 4door

rb25det

iridiums at 0.8

knn filter

full 3" although cat isn't hi-flowed

bleed valve standard boost ( we changed the boost in increments from 7-10psi and onlly made 2-7 hp difference

this was extremely concerning as it only put out about as much as my 900kg datto which is still pathetic.

any one else seen these types of figures.

I know there is nothing wrong with the dyno as it is the one from the recent summernats hp heroes the one that ran 1470rwhp on it, apparently most accurate in oz. i will have to tune next week but i wouldnt think that coil packs would make that much difference would they we should expect arount 200-210rwhp

comments thoughts

Link to comment
https://www.sau.com.au/forums/topic/40620-concerned-about-dyno-hp/
Share on other sites

yeh i know would coil packs rob me of that much power, the air fuel ratio was cool, the curve looked ok then bang straight back down at around 4000-5000, which is where my misfiring is, hmmmmmm, i have found that it only seems to happen under heavy load, ieif i run the accelerator easing it on lightly all the way to redline, it seems to pull the right way, but if just plant my foot nothin after the 4ish you just get the missing,

sounds like car has similar mods as mine not to sure if yours is full 3" is turbs back, butwe did notice that the standard cooler is crap as we were spraying water on it and was just drying so quickly, fmic would be handy, even yours to mine 134 to 170 is a big diff!!

we could have taken it higher but it wasnt making any power past 4000rpm

That power at those particular revs sounds about right. But you should continue to make power til about 6400, or even more with your mods eg exhaust. Peak power arrives t 6400 on a standard car. hopefully its just the coil packs.

I would think if a coil pack works ok at light load, it should also work ok at full load. Not 100% on this, but you could prolly use an Insulation Resistance tester (megga) on the 1000v scale to test it (know any sparkies?). The primary winding should have continuity from one end to the other and should not be shorted to earth. I think the secondary should also have continuity from the plug top to earth on the coil pack. Please correct me if i'm way off the mark!

rb25 you would think that yours and mine should be making more power, they are around 180-190 standard from factory?

there is wear and tear but we had an older supra on there similar mods 4 years older no rebuild more kms and put out 200rwhp and they come out with 187kw factory same as skyzers i think?

similiar problem to my tuning at CRD. Mine's FMIC, unichip, full exhaust, EBC

made 163rwkw with a stuffed coil pack, replaced it and made 181rwkw on 7psi.

Jim @CRD suggested gapping the plugs from 0.8 to 0.75 if wanted to go on higher boost as the spark was breaking down with more than 7psi. Gapped it and had a test run on .8(11psi) and .9(13psi)bar, sweet.....

I had this problem on my car....the engine was misfiring and spark was breaking down at high RPM (4000 or above). Had the workshop check it out and found that 2 of my coil packs were on the way out. I bought 2 second hand replacements from the for sale section on SAU replaced the old ones and now everything is sweet. In the meantime while running with the faulty coils the workshop regapped the corresponding spark plugs closer in order to try and reduce the misfiring. As more load is put on the coils, the spark breaks down more and arcs out causing the misfire. Check your plugs as well because there could be a lot of deposit on them which may be fouling them as well.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I drive the Tiguan much harder than the Skyline in all conditions, because it just grips and hooks, unlike the R33 shit box
    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
×
×
  • Create New...