Jump to content
SAU Community

Garret Gt3076 .63, Hks Low Mount Manifold, Tial Waste Gate With Screamer


Recommended Posts

Hey all

Have a gt3076 .63, 4 bolt rear housing, external waste gate

Comes with oil/water lines

Has only done a couple thousand km's. great condition

Has some scratches on the intake side due to intake pipe rubbing, nothing major.

$1000

HKS Cast Manifold, low mount, with external waste gate provision

I had the surface machined flat when i got it, has been test fitted since but never run since.

Includes genuine nissan head to manifold and manifold to turbo gaskets, only been fitted never run

$650

Tial 44mm waste gate with screamer pipe

$250

3" dump/front pipe to suit 4 bolt rear housing, with 02 sensor

with metal gasket

$200

Will do the lot for $2000, also have intercooler pipes to suit this setup

Will make 300rwk no worries with awesome response

Located in sydney

post-3412-0-22359200-1347155002_thumb.jpg

post-3412-0-82634600-1347155039_thumb.jpg

post-3412-0-83132400-1347155066_thumb.jpg

post-3412-0-97899300-1347155092_thumb.jpg

post-3412-0-68521100-1347155176_thumb.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Any chance the zero demand ignition table is messed up? Or possibly the minimum tps for it to engage zero demand?
    • 32010-AA520 - R34 RB25DET manual transmission, you can buy this new. You'll need a pull to push type clutch converter (to use R33 clutch kits), or buy pull-type clutch (R34 clutch).   R33 part number if you're lazy: 32010-21U00     Applies: RB25DET.MT.F5; Notes: FS5R30A
    • Hi All, Ive recently pulled my head in and gotten started on my 2year long project for my R32 RB25 swap, I went into it head high and confident it was an easy swap and plug and play wiring. I was wrong. The engine is a S1 RB25 and I'm running RB25 ECU And loom. I got the swap done a few weeks ago and have been working on the car on my time off, however i cannot get the engine to run, at first the engine would crank however the fuel pump would not run,  i dove a little deeper and realised that i would need to connect the wires from the RB25 Body Loom and the RB20 Body loom. went through the ECU pinout and followed the wires from the Body looms one by one to find what was needed to start the car. Now I have rewired the RB25 loom with the old R32 Body loom attached, however i am still having issues starting the car, now the pump works but still wont fire.  The car has spark but looks very weak, however I'm suspect that its not getting any fuel. I have read a few posts related to the "Main plug" near the air intake however cannot find any information on what wiring to hook up to where.  If anyone has done this swap, or has any knowledge at all on RB25's into 32 i would really appreciate your comment regarding this, im really keen to get this car finished.  Thanks in advance
×
×
  • Create New...