Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

Nothing wrong with those squats.

If I had to nit pick I would say that the first 2 reps were more controlled than the last 3.

Pause it at the bottom of each squat.

see how much of the word Hammer Strength you can see on the safety bar.

you'll find that you started drifting forward a little.

so you either didn't stay as tight or started going down before beign completely ready.

but you're movement was the same for each rep and you went deep enough.

If you can keep the same form at higher weights then it's great.

Edited by TTT

Nothing wrong with those squats.

If I had to nit pick I would say that the first 2 reps were more controlled than the last 3.

Pause it at the bottom of each squat.

see how much of the word Hammer Strength you can see on the safety bar.

you'll find that you started drifting forward a little.

so you either didn't stay as tight or started going down before beign completely ready.

but you're movement was the same for each rep and you went deep enough.

If you can keep the same form at higher weights then it's great.

Cheers mate. Yeah they were a bit sloppy I'll admit, was the absolute end of my squat sets and only bothered doing them to record it :P Still getting back into them again so I fatigue quickly, though I'd just done a couple of sets @120kg :D

man i cant squat that low with no weight.........

See this:

it's actually easier to hit depth with weight.

Honestly, I can pull 20 reps of 60kg easier than 20 reps of nothing. Likely it's all to do with the weight adding balance and stability or some shit, but it still boggles ze mind :P

Got my mate to film me squat and dead today...Been copping a recurring injury to my glutes/hips that is seriously limiting my weights so I'm after some feedback on my form to see if that might be causing the issue.

Only got 100kg on the bar in both vids so there was some weight that would get me closer to the form I'd have with heavier weight, but not enough that I'd flare up the injury that is still lingering.

http://smg.photobucket.com/albums/v218/madwob/?action=view&current=20121013_105145.mp4

http://smg.photobucket.com/albums/v218/madwob/?action=view&current=20121013_105145.mp4

It's tough to describe but I'll give it a go

The feeling it gives is like my upper outer glute & lower back muscles are twisted...

Makes squatting/deadlifting a no go when it's bad, and even kneeling down or bending over to pick something up is a mission

Lately I've been using the foam roller before every session, releasing the IT band after reading that it may cause lower back and knee pain which I was getting.

My knees don't really feel sore anymorem but the lower back and glutes is always lingering... I'm starting to think there might be a pinched nerve or something like that...A few weeks back I was warming up on squats, started at 60kg, next warmup was 80kg, and as I hit the bottom of the rep, I felt a sharp pain shoot up my back from my glute, and that was the end of the session, over before it started.

When I played football I did my hamstrings 5 times, once on the left (then never again) and 4 on the right (1-2 of those were just light re-strains when coming back). Then the year I decided to hang up the boots, I hit the 5x5 program over what would have been the pre season, did no running at all, was squatting/deadlifting 160 for 5-6 reps at about 82kg. Then the start of the season came around and I got the itch, so I pulled on the boot having not trained for it at all, and managed to play the entire season without a hamstring injury (I'd say due to the core strength gained)

Problem now is I weigh more (90kg carrying a bit of a gut), but I'm lifting much much less (120kg x 6 squat yesterday trying not to flare this up again, 130kg x 6 dead with a belt 5th, 120 x 6 without in the 4th set) Pretty frustrating with the constant up and down of weights due to injury, but I'm still in there working away at it... I've always used massage as a cure, but I'm thinking of seeing a chiro for a look over to see if there's any obvious issues.

I also think my right leg is slightly shorter than my right. Not sure if it's directly related, but the bulk of the soreness is on the right hand side, so it's worth a thought.

It's tough to describe but I'll give it a go

The feeling it gives is like my upper outer glute & lower back muscles are twisted...

Makes squatting/deadlifting a no go when it's bad, and even kneeling down or bending over to pick something up is a mission

Lately I've been using the foam roller before every session, releasing the IT band after reading that it may cause lower back and knee pain which I was getting.

My knees don't really feel sore anymorem but the lower back and glutes is always lingering... I'm starting to think there might be a pinched nerve or something like that...A few weeks back I was warming up on squats, started at 60kg, next warmup was 80kg, and as I hit the bottom of the rep, I felt a sharp pain shoot up my back from my glute, and that was the end of the session, over before it started.

When I played football I did my hamstrings 5 times, once on the left (then never again) and 4 on the right (1-2 of those were just light re-strains when coming back). Then the year I decided to hang up the boots, I hit the 5x5 program over what would have been the pre season, did no running at all, was squatting/deadlifting 160 for 5-6 reps at about 82kg. Then the start of the season came around and I got the itch, so I pulled on the boot having not trained for it at all, and managed to play the entire season without a hamstring injury (I'd say due to the core strength gained)

Problem now is I weigh more (90kg carrying a bit of a gut), but I'm lifting much much less (120kg x 6 squat yesterday trying not to flare this up again, 130kg x 6 dead with a belt 5th, 120 x 6 without in the 4th set) Pretty frustrating with the constant up and down of weights due to injury, but I'm still in there working away at it... I've always used massage as a cure, but I'm thinking of seeing a chiro for a look over to see if there's any obvious issues.

I also think my right leg is slightly shorter than my right. Not sure if it's directly related, but the bulk of the soreness is on the right hand side, so it's worth a thought.

Does sound a bit like my SIJ bullshit on a good day. Other than taking a heap of time off from deads and squats, I've found hamstring stretching to help SO MUUUUUUUUCH. This specifically:

hwkb17_055.jpg

You need to get close enough that it's uncomfortable as f**k to keep your leg straight with your pelvis/back FLAT on the ground, but not so unbearable that you can lay there for 3 or more minutes. Keep your toes pointed AWAY - ie, don't pull them towards your body. This is a hamstring/glute stretch, not calves and back :P

Along with some isolated glute stretches.

im a bit confused watching those video's, how do those guys lift so much weight, they dont look big enough to do it,

i was of the belief that muscle size directly related to how much you lift, not saying these guys are skinny or small , just saying they dont look anything close to a dorian yates or a Tommy platz in the hay days..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Everything I found online said never use it because it'll dramatically reduce belt lifespan.  No, but I have seen excessive v-belt tension cause the audible bearing noise from excessive radial load in things like alternators. So don't overdo it. Ideally you set it to manufacturer spec using a proper belt tension guage. I tried the "clicker" type gauges but those cheap things are trash. They read way too low even when you're careful.
    • This is kind of where I've ended up for the most part. It's easier for me, easier for shops that don't have to deal with my weird criteria/picky standards, etc.
    • Will do. Suprised if it's not the starter motor considering it's 30 years old. Will get a volt meter though. Battery is close to new.   Cheers for your help, always appreciated.
    • This almost never happens these days. No. Clean your battery terminals and make sure they are tight. Use sandpaper on a dowel if you have to, to get oxidation off the inside of the terminals, particularly on the -ve. Check the earth cable from battery post to chassis ground and engine ground. Make sure the contact surfaces are clean - including the threads on the bolts that anchor them - because that's where a lot of the contact occurs. Wire wheel on a drill is a good thing for this. Make sure the crimps on those cables are all sound. Assuming none of that causes an improvement: Check the battery voltage after it has been resting for a while. If it's at the lower end of the range, put it on charge for a while, then see if it will crank better.
    • I just checked my belt, it wasn't super loose but I could bend it past 90 degrees a small amount so I tightened it up and for the first time ever my car didn't crank first time, had to crank it again lol. Don't know if that was because I tightened the belt or if it's my starter motor going out (been having slow starts for some time). Coulda also been when I was recording I didn't crank the key properly and it didn't save the recording lol.   Is that a thing if you overtighten a belt it struggles to start?
×
×
  • Create New...