Jump to content
SAU Community

Recommended Posts

I checked out a R34 25GT Auto Coupe today and some bits have got me a tad bit but does not worry me too much. I just want some opinions on it:

Nagoya Motors

This car was originally bought from Nagoya Motors. Can anyone give feedback on their cars they bring in or any experience with them?

Also complied on the 10/10/11.

ODO Reading

On the import papers, it states that it has done a little over 42,000 KMs (yes I did not miss any digits). Bright red flag here given that the fact the car is 13 years old. 99.99999999999% sure that it has been reset. But the interior is pure immaculate and I've never seen such a clean R34 GT before which supports the KMs by a 00.0000000001%. Barely a nick anywhere.

Should I be too worried about the KMs? Is there any way to verify the KMs?

All panels seem nicely aligned but I'm lead to believe the boot lid was replaced since it has a GTR badge on the lower right corner where your usual GTR badges would sit. Badge also looks genuine too.

Body

Driver side fenders have a big dent due to a hit and run, clean dent, no paint scratched off or severe enough to effect other parts. Could be a bolt on/off replacement?

Front bar is a fibreglass copy of the Altia bar that has minor crack.

Engine Bay - Googled Pic Attached for reference.

Some strange wires leading from what appears to be a factory fitted unit that sits on a golden bracket on the top left corner (driver side) of the engine bay, where most R34's I've seen have it removed. There is several wires leading from it, a few leading to the horn. Didn't get a chance to snap some pics of it but googled an image to get an idea.

Also "Y" pipe where the air intake is connected, has silver paint spray on it which I'm bit sus on.

Others

Nissan GPS unit still operational and in japanese - Can we convert signal to be used here?

post-77866-0-96876300-1350132622_thumb.jpg

GPS: as in the OEM fold up screen on top of the dash? if so - not doable and its a hand grenade anyway. I have built a system that "looks" oem but was not.

GPS: as in the OEM fold up screen on top of the dash? if so - not doable and its a hand grenade anyway. I have built a system that "looks" oem but was not.

Nah man not that one. It's a single DIN GPS unit thats in Japanese. I assume it's OEM since it does have Nissan printed on the unit and is in Japanese. It's still operational but don't know what it says. It's got a flip up LCD.

Nah man not that one. It's a single DIN GPS unit thats in Japanese. I assume it's OEM since it does have Nissan printed on the unit and is in Japanese. It's still operational but don't know what it says. It's got a flip up LCD.

then its the dealer fitted clarion. not worth the effort. $1300 buys a new clarion navi anayway.

The spray paint will be from someone respraying the engine cover. A true series 1 cover has red writing and is very rare to find in perfect condition. Next best thing is to spray solid silver to look like a series 2 cover. I was offered stupid money by a dealer for ny cover which was a perfect S1 example.

In the spot, What goes here, some kinda module/relay for 4wd models.

But I've seen the bracket that holds the module on almost all the 25GT's I've seen. Why would they need a 4WD relay?

The spray paint will be from someone respraying the engine cover. A true series 1 cover has red writing and is very rare to find in perfect condition. Next best thing is to spray solid silver to look like a series 2 cover. I was offered stupid money by a dealer for ny cover which was a perfect S1 example.

The cover isn't sprayed and the red letters are still there. no signs of overspray around the cover, just the metal bit.

Nah its not man. I didn't get to snap any pics cause my phone was half dying and sunlight was low. Thinking of going in again today to snap some up with an SLR.

Edit: managed to find a pic online from the dealer it was bought from

You can see there is two wires blue and white on the bottom left corner of the pic, those two wires lead to the horn and to the black box where I asked "what goes here". Also you could slightly see the silver paint spray in the pic as well

post-77866-0-85353900-1350177628_thumb.jpg

But I've seen the bracket that holds the module on almost all the 25GT's I've seen. Why would they need a 4WD relay?.

Had more of a proper look at fast, the black box that goes there is the Wiper amplifier, the other smaller clip on bit is for a relay for 4wd models.

Had more of a proper look at fast, the black box that goes there is the Wiper amplifier, the other smaller clip on bit is for a relay for 4wd models.

Oh right. What does the amplifier do and why would it be removed from most cars?

To bad mines not on sale till august next year lol no bs attatched. This sounds a little dodgy to me

Mines got 110 000km and the interior looks half the kilometers so interior is not always good judge of KMs.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Details: Turbo Borg Warner EFR 9180 with 1.05 rear housing Upgraded TurboSmart integrated BOV Sanded and powdercoated compressor cover in gloss black Elbow welded with wiggins clamp Speed Sensor(Not included) (Can include oil drain(heat wrapped + titanium intake pipe with almost new filter for a tad extra). Manifold: 6 Boost RB26/30 twin scroll manifold  e-MAP ports drilled into both scrolls(I was using the TAARKS EMAP KIT) Turbo is in excellent condition. Always used Penrite 15w50 Racing oil(Changed less then 2000ks). Also using the Turbosmart OP regulator and filter. Downpipe: 4inch Stainless steel with VBand inlet and outlet clamps(included) Heat wrapped Dual ports for Dyno/Wideband usage Will throw in free 2.5 inch intercooler pipe(2.5inch From turbo outlet to 3.5 inch intercooler) - Powder coated black. Turbo made 563rwkw on mainline hub dyno at around 24-25psi boost - Pump fuel. Will def make over 600kw on e85. Didn't bother as my e-MAP was through the roof with my setup sitting past the choke line. I have a cnc ported and fully built head on my 3.2. Turbine speed saw max of around 109k rpm. I'm running this on my R32 GTR, with AC, and the original power steering pump. The manifold clears the AC lines, ABS, and everything else. Although I had new AC lines because I just wanted new ones and I heat wrapped them as well. This will make more power on a slightly lower capacity motor with a higher PR. And I have since upgraded to a G45-1500. Have pics and videos if need be.  Absolutely nothing wrong with setup. Turbo is in perfect condition. No shaft play or oil leaks at all. All the work was professionally done. The transient response of this is fkn amazing. I cannot rave more about this turbo. If I wasn't chasing 4 figures, I would have kept it. $5000 NZ. Located: Auckland, New Zealand.    
    • I particularly like the look of the John Player Special team. (Thumbnail isn't different but hit play for the clip)  
    • Such a cool collection of cars back then.  
    • Mystery solved, thanks bro Bit of a strange mix, but i dont mind it, still looks good. 
    • nah no problems with bearings or hubs.  just the water pump leak and my AC death
×
×
  • Create New...