Jump to content
SAU Community

Recommended Posts

as above need them gone asap.

they are the series 3 ones with purple stictching

only pic i have atm sorry for bad pic.

one has 1 slightly small ciggie burn

both are excellent condition love these seats good upgrade from any stock seats..

rails will fit a r32, r33, s13, 180,

location is hoppers crossing

0430078630 sms only

asking $1200 ono

no swaps

2012-01-29115117_zps5943545f.jpg

Do the rails fit r34 gtt and recaro sr3? If so do you want to part the rails

FYI R34 gtt has its own unique floor pan, 32-34 seats are interchangeable EXCEPT 34 gtt (and gt i think)

FYI R34 gtt has its own unique floor pan, 32-34 seats are interchangeable EXCEPT 34 gtt (and gt i think)

Thanks buddy I'm still a noob at skylines, how would I go about getting rails for the gtt is it only the bride that make them?

i dont even think its a ciggie burn looks like more of a scratch/pin hole passenger seat. just thought i would mention it ...:)

  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
    • You think its the AFM? I know its a common issues on R32s. I find it coincidental how this issue raised right after cleaning the fuel system. As everything except the fuel system was fine before. I tried running it with the IACV unplugged but did not notice a difference and still stalled. However, the RPM gauge is not in the cluster right now, so I will need to connect the laptop again and use Nistune to check the RPM. I will check this weekend.
×
×
  • Create New...