Jump to content
SAU Community

Recommended Posts

Hi all,

wondering if anyone has anything similar occur....

Basically on startup, the power steering is very noisy but then goes away once the car has warmed up.

The power steering pump has had a full reco around 18 months ago. Before then, the noise was constant.

Any help would be greatly appreciated.

cheers

Is the fluid aerated/bubbly in the reservoir?

100% its p/s? Dropped the belt and rechecked ?

Would suck if say it was an idler or tensioner pulley and just sounded like it was coming from p/s pump area then let go

Not sure, it's just really strange that on a cold morning startup the car is fine, no noises. If right then I do a dry steer, the loud noise starts. Once the car has warmed up a bit, it's all perfect and quiet!!! What the!!

  • 10 months later...

Not sure, it's just really strange that on a cold morning startup the car is fine, no noises. If right then I do a dry steer, the loud noise starts. Once the car has warmed up a bit, it's all perfect and quiet!!! What the!!

Pulling this up from a year ago but did you ever fix this problem....mine started doing this exact same thing this morning :(

this was the symptom of mine as the power steering pump was getting on - noisy when cold and dry steering, then would go away.

it will gradually get worse if it is indeed the PS pump.

bottom line is you can leave them for a while without any trouble.

Mine started having a noticeable effect on the slow speed steering when the car was still warming up until I did anything (replaced the PS pump).

good luck!

You can try replacing the fluid to help with cold temp steering. As fluid gets old and sludgey and is thicker than normal when cold. This means it isn't lubing the system as well. Draining the fluid and replacing it with fresh fluid can help.

I have to get around to doing it to my Commodore at some point (when I could be bothered, along with finding the cause of the slight misfire it has). had a leaky pump for ages and had put some stuff in it that was supposed to slow/stop leaks. Basically it was a thick fluid. I finally got a new pump but didn't completely flush the system (just topped it up really), so on cold mornings the steering has a bit of a notch just off straight. Once it warms up it's fine. I did some googling and that's when I found out about flushing the system (which made sense, since the fluid is thinner when warm, and on really cold mornings it was much worse, to a point where on a sub zero morning I had no power steering the first time I tried to turn the wheel).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...