Jump to content
SAU Community

Can someone tell me what purpose this metal weight servs inside......


Recommended Posts

Hi,

Can someone tell me what purpose this metal weight serves inside the steering wheel above the airbag? Please? It sits suspended above the horn clips and the airbag and seems to correspond to the 4 pins allocated on the plastic cover. The four rubber pieces have separated and been off for a while. I was under impression it was some small part that was retelling inside. The part is suspended in air by the 4 rubber pieces holding it in the position and streches as you drive. I think its some sort of weight. My opinion is that it is some sort of safety weight that stops the steering cap from hitting you over the head when the airbag goes off. That is my view from design background. I don't see what else it would be. Can someone help with the explanation and a solution with the part?

Thanks heaps

Al :Bang:

well it's a POS cos mine started clunking a few months bag...

A torx T50 Privacy bit is needed to get the f**ker out tho!!

Mine's still sitting in my glovebox..... just waiting for an impatient tailgater to hurl it at...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Might piggy back off this thread since there's been a good discussion about PWM.   I purchased a Walbro 460 F90000267 and have been looking into PWM to understand it. It was purchased more of a future proof as my original OEM fuel pump died (r33 below 200kw) and figured I'd just upgrade it to this. That's when it hit me that a pump this big can cause more dramas with such high amperage draw and heating of the fuel pump being on 100% all the time in such a mild setup.   I have a Nexus R3 and slowly collecting power mods but I was looking into the PWM feature on the NSP software:   Then looking at the graph from the fuel pump:     Am I safe to assume reducing duty cycle to 50% for example would make the pump run like a 230/lph ? Where does the PWM come in all of this ?   I've gone down the rabbit hole of PWM fuel pumps and it seems there are many differing opinions on how to go about it 馃槄  
    • Thank you, this will keep me busy for a bit.  I will update progression.
    • That specific one would be an exchange part, meaning I'd have to send mine to them. Plus it looks like a non AWD sump, which won't work for me. There is one or two shops in my country that I can ask to do a sump extension job and it'd most likely end up being cheaper than sending mine to AUS or NZ and getting one back, and quicker too.
    • Rear turbo is leaky, most likely at the oil drain. From what I could see with my boroscope it seemed to have seeped out at the very top of that return hose. Is it possible that the oil climbs up that hose to then leak out? Yup, coolant leak on the hot side of the engine, only noticed after seeing clear rusty residue in the block right from the turbo oil feed downwards to the pan, and red droplets hanging from the pan. No clear sign yet from where it comes, and most of the lines there are hardlines right? Last year, seeing those red drops, I thought it was power steering, will be glad if that is not leaky at least. Another leaking hose I found by chance is the lower of the two heater core hoses coming from the firewall to the back of the head. That one is not too bad to get to if I have to replace.
    • I think for response I'm already kind of out there no? he -5s are not the best pick for that as the Internet tells me. Maybe I should switch to -7s while I still can? Though that almost definitely warrants an engine pull along with the other issues I have.
  • Create New...