Jump to content
SAU Community

Recommended Posts

Brand New Apexi Power FC Boost Controller, suitable for the models listed below.

415-A001 To Suit PowerFC

Skyline - R33 GTS-t S2 - ECR33

Skyline - R33 GTS-t S1 - ECR33

Skyline - R32 GTR - BNR32

Skyline - R33 GTR - BCNR33

Skyline - R34 GTR - BNR34

Silvia - S14 S1

Imprezza - GC8/GF8 Ver1-2

Pulsar GTiR - RNN14

180SX - RS13 (CA18DET)

Purchased this two weeks ago to go with a turbo upgrade for my GTR but have since decided to keep the stock ceramics for another 6 months due to overseas work. If somebody would like to give me what I paid for this I would be happy to sell it, otherwise I'll hold onto it for another 6 months.

$455 Express posted Australia wide (no bargaining, these are rare and I'd sooner keep it than lose money on it)

Located Adelaide/Melbourne depending on work, please PM for details.

post-97177-0-82237400-1352284450_thumb.jpg

post-97177-0-62755600-1352284405_thumb.jpg

post-97177-0-85228100-1352284441_thumb.jpg

post-97177-0-83589900-1352284430_thumb.jpg

post-97177-0-84870000-1352284418_thumb.jpg

post-97177-0-60350700-1352284462_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There's more than one way to skin that cat, and most of the sump Maatouks have done will be GTR sumps. They are HUGE in GTR drag racing here.
    • Yeah...I always start at the shift solenoids, because there's only a few reasons these will spook into limp mode, and bad shift solenoids is one ~ the other can be the shift control module (if you have steering wheel shift buttons)...it's easier to eliminate the solenoids first.
    • Might piggy back off this thread since there's been a good discussion about PWM.   I purchased a Walbro 460 F90000267 and have been looking into PWM to understand it. It was purchased more of a future proof as my original OEM fuel pump died (r33 below 200kw) and figured I'd just upgrade it to this. That's when it hit me that a pump this big can cause more dramas with such high amperage draw and heating of the fuel pump being on 100% all the time in such a mild setup.   I have a Nexus R3 and slowly collecting power mods but I was looking into the PWM feature on the NSP software:   Then looking at the graph from the fuel pump:     Am I safe to assume reducing duty cycle to 50% for example would make the pump run like a 230/lph ? Where does the PWM come in all of this ?   I've gone down the rabbit hole of PWM fuel pumps and it seems there are many differing opinions on how to go about it 😅  
    • Thank you, this will keep me busy for a bit.  I will update progression.
    • That specific one would be an exchange part, meaning I'd have to send mine to them. Plus it looks like a non AWD sump, which won't work for me. There is one or two shops in my country that I can ask to do a sump extension job and it'd most likely end up being cheaper than sending mine to AUS or NZ and getting one back, and quicker too.
×
×
  • Create New...