Jump to content
SAU Community

Recommended Posts

ONLY GTR R32s are invited for this photo shoot. Come along and get some great shots of your car. We will have some models present as well on the day. If you wish to bring a model feel free :) I will have two or three models attending on the day :)

link to event on facebook

http://www.facebook.com/#!/events/446273865431755/

  • Replies 128
  • Created
  • Last Reply

Top Posters In This Topic

I'm up for this........ I may well bring the ADM as It's been cocooned since the Skyline Nationals.......

I'd actually like to get an R32 Register together. When I bought my car there were R32's everywhere, now I'm luck to see one or two on a run. Where are they all?

Bob.

in people garages with dead engines

All jokes aside, I see R32's continually being requested to be fasted in that thread (VIN's you want fasted) but hardly ever see them on the road. I've had my ADM for a bit over 2 years now and I've had my JDM for 9 months yet can't seem to find too many others. Even at the SAU Nationals there were only a handful.

I really hope a few turn up to this event as it's important to form a register.

Bob.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Dose is unaware just how much fun 145-150kw would be in a 2.5L NC MX5. It would be one of the most fun things to drive to ever grace SAU.
    • Same thought crossed my mind ~ depends on how one connotes 'stalling'...ie; gets a rough/stumbling idle as it get warm until it stalls... or... idles ok and simply falls-over when it gets to temp... ...you can test the whole circuit with a couple of resistors ...unplug coolant temp sensor, bridge terminals with a 2K7 resistor (ECU will do cold start), or with engine warm bridge with a 330R resistor (ECU will consider engine to be at normal operating temp)...it's a quick way to check wiring integrity/ECU response when you don't have a multimeter handy ...
    • They also make them with the motor mounted on the side 
    • Just be warned that that turbo will not be a direct re-fit to the car. The exhaust housing is, of course, in the same place. It has to be - it's bolted to the exhaust manifold. So the dump will fit up. But the centre housing is not as long, so the comp housing will move backwards. This will affect both the turbo inlet and the outlet. There is fab work that needs to be done. Yes. it has one, it should have one. Paper gasket.
    • I only recently purchased the vehicle, it came with the flex setup but the current tune is e85 only, which is why im wanting to get the tune redone to enable a mixture.  First i need to get the exhaust redone tho. I was thinking of getting a varex muffler but it sems they dont fit well in the 33 (hang low because of the valve mechanism which sticks out on top) and generally dont sound good. So that leaves me with redoing the entire exhaust (more resonators and mufflers) so its not a menace when i come and go from home, and then have the aes dump valve somewhere along the line to really open it up. I was thinking of having it before the cat but after seeing how insanely loud it will be (on a vl turbo) im thinking of putting it more towards the rear of the car, after one of the resonators. 
×
×
  • Create New...