Jump to content
SAU Community

Recommended Posts

HI all,

So i just recently got a second hand engine installed after i blew my last one up..

all is well except for this really annoying cough/splutter on a cold start just off idle...

if you try and put any load on the engine when it is cold (around 1000rpm) it will cough and splutter to the point of stalling.

i recorded a video so you will know what im on about:

i have replaced:

Leads (top gun)

plugs (NGK)

Air Regulator (off another motor)

i also took the injectors, fuel rail and afm off my old motor which had no issues and it still does it.

if its worth mentioning:

1. Car is a manual conversion (never had issues before)

2. all is fine when it is warm

3. it seems to idle a lil low when cold(around 800 - 900rpm, could be more or less as i have a sticky tacho), but a little high (1100 rpm when warmed up)

Link to comment
https://www.sau.com.au/forums/topic/414953-r31-rb30e-cold-start-issue/
Share on other sites

I'm not sure how R31 ecus work, in a R32 and beyond I would suspect the coolant temp sensor (not the one that feeds the dash cluster, the one that feeds the ECU), when not functioning it might not be going into the cold start map (richer than the normal one).

  • 2 weeks later...

i had issues similar to this an adjustment to the TPS cleared it up

so i have tried so far:

1, Spraying crc contact cleaner on the AAC Connector, Both sides of the coil, Air Reg connectors, tps connector......

2. tried having a play around with the tps, fully clockwise it idled lower, didnt fix the issue with the spluttering..fully anti clockwise the issue wasnt any better but it idled higher

3. unplugged afm and it idled like shit, wouldnt rev etc so i know the afm works.

im baffled as to what it is

if its not that then keep trying other similar things, 31s are getting old now and most of them have had the tits revved out of them by p platers and messed around with a lot

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Do the following first and get back to us. - Clean and verify your IACV - Verify for vacuum leaks/post MAF leaks. (Pressure test is the best and cheapest way) - Do you have a BOV with stock ecu/MAF? If so, remove it.     
    • Hey all, The skyline I have is stalling when the engine is at normal operating temp.  When starting it while it is cold, it'll run just fine.  I have replaced the battery (bad cell), I have replaced the fuel pump, fuel filter and clean the MAF sensor.  Any other suggestions?
    • Thanks for all the information on this.  I tried ordering the parts from Amayama website and all 3 Solenoids are discontinued and not available.  Does anyone have any other websites to suggest that I could find the parts?   Separate issue-- I will start a new thread, but basically the vehicle is stalling when warmed up.
    • It's unfortunate what Tomei USA has done to Tomei's name in general. I'm very weary of ordering parts from them now. I only order direct from a Japanse source (e.g Nengun). At least their logos are different, so you end up knowing what you have. 
    • Update Issues 5 (plus #4) - 10 After making a claim about issue #4's missing part, DeAgostini Japan sent a whole new issue #4 and it arrived about 2 weeks after that. That was back in early March. It took another 4 weeks to receive issues 5 - 13 though. This update is for issues 5 - 10. Ove the 5 issues the front left suspension and most of the engine have been completed. The quality of the castings and fit of the parts is quite good, it seems better than DeAgostini's BNR34 Skyline GT-R from the Fast & Furious 2 movie, which (to me anyway) doesn't seem to have as tight tolerances or quite as accurate castings.  Each issue has a lot of info about the 1989 - 1993 Skyline range and other Nissan models from that era, but the focus is on the BNR32 Skyline GT-R Nismo and the various racing it did in Japan, Europe (Spa 24hrs) and of course Australia. I've included some text translated with Google Lens in some photos and will add to them if there's anything worth including. 
×
×
  • Create New...