Jump to content
SAU Community

Melbourne Resprays

tchard

By tchard,
in Exterior & Interior Styling

 Share

Recommended Posts

tchard Collaborator

tchard

Posted
Posted

I've got a black Stagea which has an expected faded paint job.

Especially on the roof where the plastic sun roof protector was and a scrape on the rear bumper left hand side which should get buffed out.

I was thinking instead of getting a cut and polish, I'd get the car resprayed in black. No metallic, no BS, just standard black.

Any recommendations and thoughts on what I could be up for??

Engine bay isnt really necessary, just the car worked back and resprayed black.

Thanks

Link to comment
https://www.sau.com.au/forums/topic/415143-melbourne-resprays/
Share on other sites
tchard Collaborator

tchard

Posted
  • Author
Posted

Yeah I found a similar one for $1k... Seems alright

At the end of the day, its the same colour. Just the paint is a bit dull and scratched...

They're based in Bayswater I think. Might just have to give them a go and pray it turns out alright

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • sunsetR33
      ugently need expert / experienced opinion

      By sunsetR33 · Posted

      Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • Butters
      UniClutch

      By Butters · Posted

      hrmmm , not mine , easter plans to pull engine not happening     
    • DRoc81
      R33 GTS25 NA - Stalling when vehicle is at operating temp

      By DRoc81 · Posted

      I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Milkmun
      Magnetic Drain Plug Snapped in Half

      By Milkmun · Posted

      At least it was the ex.
    • Murray_Calavera
      Troubleshooting - motor wont turn over

      By Murray_Calavera · Posted

      Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...