Jump to content
SAU Community

Recommended Posts

it was when I first got the car, wasn't running! the radiator was snapped in half

I also had to do the lower control arm in mine when I got it, they are a bitch!!

and rob, my rpm stops every now and again, any ideas? my mates 33 did the same thing

Somewhere between the engine and your eyeballs. :P

I'd try checking for loose wires / dodgy earthing. Could be in behind the cluster etc...

Not hard to pull out.

(once you've done it a few times) lol

  • Like 1

Fibreglassing repairs today, all done.

The instructions say mix a certain amount so you can get it on before it hardens.

DIY Miks painting skills mean i can mix the whole tin and get it on good, well before it starts to harden. job done. :thumbsup:

I was feeling so good until i remembered... the only way to get fibreglass off is a cold shower. :O:blink:

  • Like 1

Fibreglassing repairs today, all done.

The instructions say mix a certain amount so you can get it on before it hardens.

DIY Miks painting skills mean i can mix the whole tin and get it on good, well before it starts to harden. job done. :thumbsup:

I was feeling so good until i remembered... the only way to get fibreglass off is a cold shower. :O:blink:

I found that out when helping dad fiberglass his sub box in the old f6 typhoon... not very nice!

Somewhere between the engine and your eyeballs. :P

I'd try checking for loose wires / dodgy earthing. Could be in behind the cluster etc...

Not hard to pull out.

(once you've done it a few times) lol

hahahaha!!!! smartass!!

yea I have pulled the cluster out already, couldn't find any loos wires, will look for the earth wires on the weekend :)

Edited by ..::R33GTS-T::..

Strongly recommend not letting your Skylines get so low on fuel that the fuel light comes on.

+1

I don't allow my GTR get below a qtr of a tank.

Listen or learn.

But just don't breeze over good advice, especially if you have modified your car.

got no mods, well no power mods, and I still don't let it go under a quarter

I have never had my fuel light on, and the gauge has been like 3mm under the empty line... and I sure as hell don't want to see if the bulb is broken

Make up your mind

I just made sure the intake is the same height as stock, and while i was there i could see how it gets the last bit of fuel.

Kinda dodgy baffles try to keep it near the pump, but a good corner or steep hill and it would run away and youd get air in the line.

After pulling it out and f-ing around trying to re-seal it, i still smell fuel inside the car sometimes. Have to do it again better this time. DIY LOL :huh:

Make up your mind

haha, it was heaps under when I got the car, didn't drive it, got a jerry can... im talking about I wont let it under while driving :P

but good spotting :/

As I said I've seen my fuel light come on once in 10 months. I normally fill up when it hits E, but my sender is not correct and I can only fit in 40-45 litres

Edited by dontyellpl0x

It's like fuel cut.

It can do engines in if it occurs at the wrong time

Bit dramatic I know, but it happens.

(your better of stopping spark than stopping fuel)

Edited by Sinista32

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I believe there was a similar one posted by @duggyphresh. They were re-routing their battery positive cable in the way I am also trying to achieve. Sorry, I’m new to this forum, so was a bit late to the party by a few months and so reignited the old thread, as I wanted to know how they got on with doing it.
    • Wasn't there a thread on this very subject just a few weeks ago?
    • Hi all! Looking to relocate the battery to the trunk of an R34 GTT. I want to do it using as many stock GTR components as I can (including the harness protectors from the 34 GTR that run underneath along the chassis to the engine bay). So far I’ve purchased the battery tray from a 33 GTR, as the captive weld nuts are already there just asking to be used. There is also the slight issue of now having to relocate the ABS/TC/Fuel Pump Control ECU, which in GTT’s sits right above where the battery will then sit on the tray. Has anyone already achieved this, and if you have any pics that you wouldn’t mind sharing? It would be great to see how others have done it and where you put them, as there are countless holes in the parcel shelf panel to potentially use. Just trying to get some ideas bounced around, and to help uncover any potential problems I may encounter by  my choice of location. TIA for any help!
    • Brand was ard.   I also threw a brand new battery at it and beefed up the wire from the alternator to battery and added an extra earthing point from the battery 
    • Evening all,       I'm replacing some bolts on my RB25 with probolt Australia bolts.       Does anyone know the following, m5 m6 etc 10mm 20mm etc       Coil cover   Cam covers   Plazamaman fuel rail   Front cover (timing cover)   Etc   Any help would be awesome   Or any lists anywhere
×
×
  • Create New...