Jump to content
SAU Community

Recommended Posts

Tanabe sustec pro coilovers

Suit r33 gtst and r34?

Great condition

Come with c spanners

$700

Adjustable rear camber arms

Suit r33 r34 s14 s15

$80

Front caster arms with red aftermarket bushes

Great condition

$70 pair

Blitz turbo timer

Great condition

$30

APEXI turbo timer

$30

Fet turbo timer

$20

APEXI boost gauge 60mm

$30

Garrett boost gauge 60mm

$50

Hks pod filter with adapter for air flow meter

$50

R33 front strut brace aftermarket

$40

R33 black aftermarket side skirts need slight repair

$20

Impul gear knob suit 5 speed

$20

Drift oil cap

$15

Custom one piece tailshaft suit r33

$80

R33 matching gear and handbrake leather boots

Black with red stitching

Great condition

$35

0487924497

Gold Coast

Hey guys ill be going to Sydney early next week with a car trailer so if you need any parts ill bring them with me or if you know anyone that needs a car transported from Gold Coast to Sydney I can also do that for fuel costs

Also have these

Power FC and controller

Tanabe strut brace

Sard fuel reg with lines

Front facing plenum

Intercoolee kit

Z32 afm

Aftermarket injectors unsure on brand yet

Aftermarket clutch pretty sure it's twin plate

E boost controller

Turbosmart boost tap

Superspark coilpacks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Just a follow-up on this topic. From what I can tell so far the rusty residue on the engine block might be unrelated to a coolant leak or maybe just older than anticipated. After driving it from the winter garage to my friend's garage I could not see any new traces of coolant leaking there, but I will test this properly once I was able to fully warm up the car and drive it for a bit. I think I can agree that the whole porous engine block stuff is kind of nonsense, but there is just a silly amount of true, false and half-true information on anything Skyline-related on the internet.
    • hrmmm , not mine , easter plans to pull engine not happening     
    • I removed the IACV, cleaned it and reinstalled.  I found a video on youtube that helped with the whole process, the guy then said the idle needed to be set, so the process was to get the vehicle up to operating temperature, unplug the TPS, set the idle screw in the IACV so the RPMs were around 600, then plug the TPS back in.  After I reinstalled the IACV, the car started (because, it was a cold start), once it warmed up, the car died, I adjusted the idle screw to see if that helped anything, it did not, I had to wait about 3-5 minutes, then the car would start back up. Only to shortly cut out, and only crank.  I loosened the TPS to see if adjusting that would do anything, and when I would rotate the sensor clockwise, there was a humming noise, but it would go away when I got the sensor in the horizontal position.  It only made the hum noise with the key on.  What do you guys think? 20250414_172604.mp4
    • Quick update.  The engine grounding strap was replaced, the engine is now happily running.  Tested the voltage drop before replacing the strap, was about 1.2ish volts down between engine to battery, chassis to battery. With the new grounding strap, pretty much no voltage drop at all. 
×
×
  • Create New...