Jump to content
SAU Community

Good First Turbo Car For 6-7K?


Recommended Posts

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

s14/33 gtst

but personally i would go mix match chassis n engine

32 body with 2jz/rb26

cressida with 1jz

cefiro with sr20

you have many options mate, id avoid rb25 if possible

Link to comment
Share on other sites

s14/33 gtst

but personally i would go mix match chassis n engine

32 body with 2jz/rb26

cressida with 1jz

cefiro with sr20

you have many options mate, id avoid rb25 if possible

Yeah, cause you're gunna get a good min'n'match for $7k.

RB25 is the best possible option for someone on that budget.

Link to comment
Share on other sites

Yeah, cause you're gunna get a good min'n'match for $7k.

RB25 is the best possible option for someone on that budget.

i like sr, it's cheap and not really that fuel thirsty

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share




  • Similar Content

  • Latest Posts

    • You don't need an AC mechanic to fit it. You do need one to vac the system down and fill it. That's how you get refrigerant.
    • Well, it's actually probably worse than you think. I think you have to (minimally) install GKTech's spherical bush replacements to the lower arm's inner ends, because you absolutely cannot subject the original (or poly) bushes to that much misalignment. The better option being to replace the whole lower arm with GKTech's unit. This brings sphericals to the lower inners either way you do it. And are you aware that the kit is weld in and you have to take the subframe out of the car to get it fitted? It's a fair bit of work. These issues both drive my ongoing dithering about doing this to my car, for the last couple of years.
    • The website said you need a AC technican to swap it in. Is that true? How did you fill the refridgerant? Was it easy to install?  If i just got the bracket and the new smaller AC compressor, would the other components be compatible with R134?
    • Hi All Finally getting back to work on the R32 this weekend and had a quick question about the GKTech anti squat kit (https://au.gktech.com/products/s13-180sx-r32-subframe-anti-squat-reduction-weld-in-kit?_pos=39&_fid=eb6b5077e&_ss=c) So, this straightens out the rear LCA and increases the roll centre by 20MM which is great BUT I also have MFR roll centre adjusters (https://www.rhdjapan.com/moonface-super-lap-rc-joint-roll-center-adjuster-bnr32-ps13-rps13.html) which gives a +15MM lift. My question is whether they can/should be used together or if its going to massively effect the geometry? In my mind, I can't see that they work together but was hoping for some feedback on someone who has done this before deciding which to use or if both?   Thanks
    • Agreed. Thing has to be running absolutely pig rich as well. I would worry a lot less about your idle and start going through all your electrical before the car burns down. 
×
×
  • Create New...