Jump to content
SAU Community

Recommended Posts

Looking at fitting harnesses in my stag as when cornering at speed you have to brace yourself a bit at the moment. Anyone else fitted harnesses? Wanting to keep it practical with useable back seats so was thinking either a double release harness. Original plan was to put a harness mounting bar behind the front seats but not found any for stageas.

Link to comment
https://www.sau.com.au/forums/topic/419782-racing-harnesses/
Share on other sites

Yep I fitted a couple of Recaros from a Euro Honda or something - more comfortable than a race seat for my daily driver but heaps more control on the track. In this country (don't know about UK) if you fit a harness you have to be a member of a car club, run a log book etc.

Yeah reclining are ok. It's to do with cutting people out of cars. Harnesses have to have a red release button so can easily by identified and seats must recline so they can get you out on a spinal board. It's meant to come into affect in April, they tried about a year ago but realized none of the mot garages were prepared.

Yeah reclining are ok. It's to do with cutting people out of cars. Harnesses have to have a red release button so can easily by identified and seats must recline so they can get you out on a spinal board. It's meant to come into affect in April, they tried about a year ago but realized none of the mot garages were prepared.

As much as it pains me; that's actually a very smart policy.

At least there's logical reasoning at play in the decision making process; rather than the usual "Don't do it or we'll fine you" mentality we have in Australia...

Providing you have a WC34 Stagea a relativly cheap and good looking option is a pair of front seats out of a R32/R33/R34 GT-R. I believe they bolt straight up!

Personally I wouldn't be using a harness on the street anyway. While you are strapped in you can't move your body to look around properly (ie checking blind spots while merging lanes and parking)

  • 1 year later...

Honestly I found I could corner much faster while held in with a decent seat - I have used an aftermarket bucket seat and also a Recaro from a Euro Honda and both gave excellent results. I suspect a GTR seat would be also be ok and would have the advantage of bolting straight in to the existing holes without the need for an aftermarket seat base and slider.. As part of my cert process I had to fit seat belt anchors to the transmission tunnel so pretty secure as well.

You do realize that the back seats have to be removed and the belts must go back as straight as possible so as when you go over you body weight doesn`t go on your shoulders >back , Cams stipulation read the regs also road authority.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Can't remember the last time I saw a good, healthy battery dropping into the 9s during cranking,  Too many variables to say anything about it with any certainty though.  A float voltage of 12-12.2 is tired AF and given how AGMs handle high C rate and DOD, will just die faster and faster with each cold start.   
    • I find most vehicles dip into the mid to high 9 volt range, even with a good battery. Hitting the low 9s, and especially hitting into the 8s is pretty indicative of a dieing battery. The other part to look at is the battery voltage after the battery has been fully charged. They should be sitting at 12.8V, as lead acids are dieing, they head down low and lower. Often getting as low as 12.0 - 12.2. You'll start seeing this when the engine is cranking over slowly. Interestingly, depending on the vehicle, when batteries get really bad, you can see some REALLY funky things going on. From very low voltages, to higher than 16V too. Something I totally didn't expect! This part of the super low and super high voltages I've been seeing on motorbikes, I need to do some further studies on cars. I suspect cars will act a little bit different though for a couple of reasons.
    • Thanks! Supercheap has a sale on this weekend so might be a good opportunity to get a new one. I do have a decent multimeter so I'll give it a try either way.   Hah, you got me! I do not. All I know is that the battery holds charge and sits at an okay level before I start the car. Doing the full charge and rejuvenation cycle on a trickle-charger seems to not really make a difference to the cold start behaviour. I'll try and measure it during cranking and see what it does. It's likely terrible; it certainly feels terrible.  I'll be happy if it is really just the battery and I don't have to dick around with the alternator or starter motor.
    • how do you know voltage is fine?  quick easy test is connect DMM up and put it on max/min mode, remove fuel pump fuse, crank car for 3-5s, go check min voltage You'd be surprised how many "healthy" batteries are showing under 10v during this test in cold weather. 
    • Not properly. You need to be able to dissipate 100 amps or so to doing it meaningfully. You can do it indirectly by watching to see how far the voltage falls during cranking. Unplug the coils or something else to prevent it from starting so you can get a good couple or three chugs. It also helps if you have the multimeter set up reading before you start, and that it has max/min functions. So you can catch the real minimum without having to watch the screen, which often doesn't update fast enough to show the real max/min in dynamic situations. Or use a digital oscilloscope, which can be obtained for <<$100 from Aliexpress (although I'd argue for paying up to ~$200 for a nicer one). A >4 yr old battery will very likely be well down the path to the knackery. Many only last 5-6 years these days. The cold weather lately will definitely make it worse.
×
×
  • Create New...