Jump to content
SAU Community

Recommended Posts

As the topic says, I haven't been able to get my gtr to start. It was running fine until I decided to give it a a little bit of a flogging and as I came on boost it just stalled out, when it stalled it sounded as a intercooler pipe just popped off but I have check it and it looks fine and every time I've popped a cooler pipe off it hasn't stalled like it did. So I'm not sure what to start looking for next.

Link to comment
https://www.sau.com.au/forums/topic/420327-r32-gtr-wont-start/
Share on other sites

Did it give a big "BANG" when the cooler pipe popped off?

When you crank it over do you hear the cylinders firing?

Does it TRY to run? eg Starts and splutters along for a second then dies?
Is it blowing any sort of smoke out the exhaust when you're cranking?

Check the piping once more, sometimes they'll look connected but be shifted leaking still...

Check the air flow meters are connected

Nah no bang, it turns over fine sounds like its going to start but doesn't. It also has a fresh forged bottom end so I don't think there's any dramas with the internals. No smoke that I can see.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey everyone!!  I've noticed that whenever I do my oil changes, after putting 4L in, the oil level sits at the top mark in the dipstick. This is after letting the old oil drain for a very long time too! I've checked the oil level daily for the past few mornings. It happens every time and it's confusing because all the threads say that it should take about 4.7L (With some just adding the full 5L) My next thought is to figure out if the dipstick I have is correct so could someone please tell me the length of the RB25DET engine oil dipstick?  I've checked images of some of the genuine dipsticks, but none of them have the length in it. https://justjap.com/products/genuine-nissan-engine-oil-level-dipstick-fits-nissan-r34-skyline-c34-stagea-c35-laurel-y34-cedric-gloria-rb25de-t-neo?currency=AUD&srsltid=AfmBOortQXofgmiHVRKuIaiKuygL4k0Ewp68c3isGZk0vvKOJ7Yqf3iB However.... the engraving on the genuine ones say 05002 while mine says AA000. This makes me believe that maybe I have a wrong dipstick? I just want to confirm before I buy a new one. The car is a fresh import from Japan so I don't have details of the previous owner to ask him. Thanks in advance 🙏🏾 
    • Sport. I didn’t rebleed it cause I just removed the slave and left connected.    I will change line and slave and see how it goes.  
    • Oh and how is the rattle when foot is on the clutch ?
    • Did you get the sport or track ? From what the documentation says the uniclutch has a small amount of movement to disengage.  So your story of tricky pedal setup seems common.    Hopefully you got it bled up too, as the bite point moving around is usually either plates wearing in or air in the line.     
    • There's always "MIG it up and grind it back".
×
×
  • Create New...