Jump to content
SAU Community

Recommended Posts

I bought a set of ID2000's for my GTR, but seem to be having a bit of a drama with fitting them... The inner diameter (side that slots into manifold) seems too large at 13mm to actually fit. What size are they meant to be?

Am i missing some type of adaptor that reduces the 13mm injector body to something like an 11mm tip to slot into manifold, or have i been supplied the wrong injectors??

Link to comment
https://www.sau.com.au/forums/topic/421076-injector-sizing-gtr/
Share on other sites

Anyone that confirm the above 100%?

My plenum looks as though it may have some type of sleeve in the opening, but upon closer inspection (plenum still on car) it appeared that they were a part of the original casting... Not so sure now??

Pic attached for reference.

0426F605-698C-4B1C-B2A0-5A7BCE96A5E7-186

As far as I'm aware, the injector sits hard up against that port, and is held their by the pressure of bolting down the rail.

The Id2ks don't go inside that port like a factory or jap brand injector.

Correct me if I'm wrong

The O-ring doesn't make contact with the manifold as the tip of the injector is too wide to even fit in a few mm, so i didn't think it was right. Pressure would just hold the plastic end cap down to that cast flat section, negating the need for an O-ring even, but would leak under pressure afaik??

Would love to hear from someone that has fitted a set of ID2000's to a standard plenum GTR!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • shit boxes, kids, and daily drivers are all welcome
    • Cam seals go hard. It's a very old car.
    • Also, maybe this is better in General ? 
    • Updated most. I really need to get a crawler to report on all broken links on the site.
    • So my rb is finally having more problems. 2 issues here but I'm here to just to mainly discuss the rattle noise. The other day when I turned on the car and when I take off or go in reverse, there is a temporary rattle noise but when I cruise, boost, idle it's completely fine no rattle whatsoever. I've also done all the servicing, all the health checks you can think of and it all passes with flying colours.  Also the rattle doesn't increase with rpm, it's only at a very certain rpm (slightly above 1,100rpm). My other car also has the same issue every once in a while. Changed the oil recently, no difference. Even took my oil to a lab and everything was quite good surprisingly. Timing belt changed a while ago to. Had the car on the hoist and can't see anything obvious. Tightened a couple of nuts on the exhaust manifold a couple of months ago. 2 different clips uploaded. One of them was supposed to another issue but I'll save that for another time. Thought I'd see if anyone had this same noise before, it's a bit hard to diagnose while it's intermittent. If I'm not mistaken, I think I had this a while back but can't remember exactly. I was thinking if it's doable I'll get someone to hold the throttle cable at 1,100rpm and hopefully it replicates the sound. rb25det rattle only.mp4 rb25det slow start + rattle.mp4
×
×
  • Create New...