Jump to content
SAU Community

Eoi: 19X9+11/10.5+5 Ssr/ Veilsideandrew Golt (Mega Dish)

(Locky)
 Share

Recommended Posts

(Locky) Community Regular

(Locky)

Posted
Posted

These more of a EOI as they are about a week or 2 away from landing from japan

Bought them for my V35 but after rocking 18's for a few weeks I think I might stick with them

Veilside Andrew Golt

Apparently they are not super rare, but not common either only 400 sets made by SSR, 19x9+11

19x10.5+5

92mm of dish at the front and 130mm at the rear

Would want at least 2.2K for these

a_factory2005-img600x450-13590200384ycqf

a_factory2005-img600x450-1359020038tc0sr

Look better with out centercaps, was going to try not run them or try and mod them

(Random internet pic)

128037d1217542818-fs-veilside-andrew-gol

veilside-andrew-golt-limited-edition-dis

Will be here soon

Campbelltown NSW

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • joshuaho96
      R34 GTT idle problem

      By joshuaho96 · Posted

      Adjusting the idle screw is usually (emphasis on usually) just covering up deeper issues. Stuff like the cold start valve not closing properly. Throttle shaft seals on the way out. Coolant temp sensors getting out of spec. Coolant temp sensors especially can be a bear to diagnose because they can fail subtly. My dad just spent weeks chasing down his high idle. He cleaned the coolant temp sensor and everything but the resistance curve just drifts over time and if it's been 20+ years they also get super slow to respond as well. Has a massive effect on fuel economy as if it's off the ECU is going to run richer and command high idle for far longer than it should otherwise.
    • MBS206
      R34 GTT idle problem

      By MBS206 · Posted

      How old is the battery, it's more likely your battery is on its way out.
    • PranK
      Cleaning my wheels 😍

      By PranK · Posted

      I reckon you'd get 90% off. My washer doesn't get between spokes very well. Haha! I love my Gerni!  Argh! Steam cleaning has its place for sure.
    • silviaz
      R34 GTT idle problem

      By silviaz · Posted

      Hey all, I did a voltage test with the car (video attached) not running for 3 days. And here is some interesting stuff: - Battery voltage is 12v (I had the key in the ON position) - Drops to 9.76v while cranking then quickly goes up to 14.5v - You will notice there was a sorta slow start but not as slow as it usually is. - Idle surprisingly was better at just over 1,000rpm instead of 1,100 rpm. - I turned on the A/C, radio and headlights in the video and the voltage remains the same - I haven't cleaned the grounding wires on the chassis yet, that's next. - Battery drops to 12.6v when I turn off the car and wait a bit Seems like I might have a parasitic draw? I do have an immobiliser system which does drain the battery more of course but was wondering if there is anything else I should be looking at fixing? Does the ground wires on the chassis have anything to do with the low 12v?        SAU.avi
    • MBS206
      Duncan's V37.......race car?

      By MBS206 · Posted

      My lord that is some low oil pressure as minimum in the manual! I guess the big part will be seeing how it changes as the engine gets more spirited use.
×
×
  • Create New...