Bnr34 Mfd

[rsanyongtr]

Hey guys,

I'm in a bit of a bind.

I changed out my screen on my MFD, due to several cracks.(screen 1)

screen 2 however despite being brand new, displayed absolutely nothing.

I put screen 1 in again just to make sure my MFD still functioned properly, in which worked fine.

I put screen 2 in again and still nothing

I put screen 1 in again because, i gave up on screen 2. however this time displayed only an ambient light and one of my buttons didn't light up.

anyone here experience this sort of trouble? I took my car to an electric guy and he said that the wiring fuse and everything else was alright. couldn't find anything wrong.

anyone have any tips or insight? I would greatly appreciate it.

thank you

[wedge_r34gtr]

got the right screen?

There's two different types - a toshiba and a sharp panel. They are not interchangable.

[rsanyongtr]

yes, both are sharp.

[Charles89]

If you had change the polariser film to screen 1 at the very start ($16), it woulda fixed your problem :S

[Iron Mike]

If you had change the polariser film to screen 1 at the very start ($16), it woulda fixed your problem :S

TRUE. This is a very easy fix. Check the ribbon cable at the back. It's hard to get in and out (when pulling apart the MFD) and if you break it say bye byes to your MFD and a few Gs to get a new one

[rsanyongtr]

TRUE. This is a very easy fix. Check the ribbon cable at the back. It's hard to get in and out (when pulling apart the MFD) and if you break it say bye byes to your MFD and a few Gs to get a new one

the ribbon cable? your talking about the two in the back, next to where the computer hook up port?

[Iron Mike]

If you have a Sharp MFD screen there is only 1 ribbon cable. One end is attached to the back of the Sharp unit while the other is attached to the remainder of the MFD housing/motherboard. It is very delicate and needs to be both handled with extreme care and placed correctly back into the sockets when reassembling the MFD. If you have put it back in and not all the pins of the ribbon cable are in touch with the motherboard/screen, then you will have problems.