Upper Trunion Bearings R32 Gtst: Bearing Numbers

[D.I.Y. Mik]

If you have the dreaded mystery creak in your front suspension and cant find the answer, try this:

Upper bearing: 6204V

Lower bearing: 6907L8

anyway now i have the numbers i can find the bearings

[D.I.Y. Mik]

Actually i think its 6907LB

Its very hard to read

[Frosty]

curious to know why that pic has a drive shaft if we are talking about the front in a GTST?

[GTSBoy]

Because it's the same same.

[D.I.Y. Mik]

Ha ha.. if you can find a manual for gtst ill suck your......

No, but seriously, the bottom one is very hard to find. does anyone know where to get one?

I went to the bearing shop and they found another number on it:

sfo6a26vpxi

again its hard to read, the 6s look like 8s but i think they are 6s.

Ill try and get a photo of the numbers- no my cameras not up to it

Edited April 8, 2013 by D.I.Y. Mik

[D.I.Y. Mik]

Ok people there are none to be found.

Nissan will MAKE a set for me, awesome.

However.... $150 each bearing (fair enough)....... $120 each dust seal (yeaow!)

Im saving my dust seals and repairing them.

[sonicz]

Are you guys talking about this sound?

Powered by VideoBam - Free Video Hosting

Oh and why is there a front wheel drive shaft on a gtst lol

Edited April 12, 2013 by sonicz

[GTSBoy]

See posts 3, 4 & 5

Oh and why is there a front wheel drive shaft on a gtst lol

[D.I.Y. Mik]

No not like that, its a creaking sound not a clunk clunk.

That sounds like your wheel is about to fall off dude! dont drive it.

Go get it checked out by a proffessional.

[sonicz]

No not like that, its a creaking sound not a clunk clunk.

That sounds like your wheel is about to fall off dude! dont drive it.

Go get it checked out by a proffessional.

Well I've got a full thread about it here and no one is replying, but the noise is gone, so it was either the trunion bearings or the hubs because thats all I changed.

http://www.skylinesaustralia.com/forums/topic/423302-had-both-front-hubs-control-arms-replaced-problems-now-worse-no-more-money-diy/

Anyone at least know the torque specs for when I re do the new control arms?

Ever since I had the shop put in the second hand ones, the steering feels really tight and I get tons of under-steer like some bolts are too tight and something is not flexing right.

I will be ordering new bearings next week and hopefully fitting them next weekend. Thought honestly I have no idea what I'm doing.

Edited April 13, 2013 by sonicz

[zebra]

Bearing number for those who need it

Upper Trunnion 6204V

Lower Trunnion: 62/28NC3