Jump to content
SAU Community

Recommended Posts

I have a complete r33 gtst that I am parting out, everything available except gearbox and tail shaft


some goodies like


near new garrett gtx3071r

near new splitfire coilpacks (series 2)

full 5 stud conversion

all panels and interior

3'' exhaust

abs diff

glass

18'' advanti wheels

bare engine that runs mint

radiator

complete a/c setup

ecu

engine and starter looms and lots more


please enquire for prices and pictures


pick up from 4127 or will post most items

Hey mate what u after for the 3071r to sydney 2144

its sold pending payment mate... will update if sale falls through

Got stock coilpacks?

nah only got the splitfires sorry bud

hey mate, are you selling the harmonic balancer?

yep the harmonic balancer is perfect no chips or damage pm me if keen

Cheers

for the interest guys :)

Hey mate, what colour and what condition is your paintwork.

Hey mate its silver but they only panels that are good are, bonnet, boot lid, front and rear bars (s1 front bar) and also a passengers rear quarter cut...

Also have pm'd everyone else :)

Sold so far:

engine - pending payment

diff

passengers door

gtx3071r

splitfire coils

boot interior

centre console (have a s1 console available)

drivers rear quarter glass

space saver

front and rear strut braces

seats sold pending payment

Also if anyone local is keen on any of the windows I will do them pretty cheap but must remove yourself...

  • 2 weeks later...

hey mate,

chasing the front drivers side splash guard (plastic going around the inner wheel front drivers guard) and also the bonnet lining / bonnet heat shield, if you have either of these?

how much you chasing for the front bar

hey mate I am after $100 for the front bar I am told its a series 1 m spec front bar so wont fit a series 2 apparently...

hey mate,

chasing the front drivers side splash guard (plastic going around the inner wheel front drivers guard) and also the bonnet lining / bonnet heat shield, if you have either of these?

sorry mate dont have those bits anymore

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Hi All Does anyone know what size bolts are used to mount the bonnet hinge to the bonnet on an R32 GTR please? I'd usually just buy them OEM but they are nearly £20 each and I need all 4
    • interestingly enough, i found out the answer is yes. doing a flush did fix my recurring A/T light. it might have been because of the trans filter: but that doesn't really make sense to me. the fluid/filter was super dirty. would that increase the pressure in the lines and trigger an A/T light? does the car even have a way of detecting that? i have no idea. i've done 200+ miles after the flush and no A/T light. if my A/B solenoids went bad, i would think the light would've come on. shifts and drives way better now though...at 2k rpm instead of 2500...no hesitation and downshifts when i want it to. 
    • I vote go red. Only because I hate keeping gloss black clean. Was no worries helping out either! Glad you've survived the rain outs of QLD
    • I would again like too thank Matt for his help in me sourcing the detachable hard top for the little red car, without Matt's assistance in inspecting it and locking it down, I can guarantee it would have sold before I could get up to see it,  and as that was the only available NC hardtop in Australia, I consider myself extremely lucky on multiple levels To say I'm more that happy would be an understatement And, it is 100% water tight, I drove through torrential rain coming back south, and by torrential, they type of rain that doing 40kph in a 110kph zone was a real thing, and even then, the standing water on the Hwy was deep enough to throw waves I'm also more than happy that the huge "BEASTS" that Matt calls dogs didn't eat me for lunch, I'm sure the sniffs and licks were more to "taste test" me, over being to friendly Now to work out what colour to get it painted, panel match, or gloss black........first world problems are real
×
×
  • Create New...