Jump to content
SAU Community

Recommended Posts

Hey all

I just put on my bov, i ideals fine but had a stalling problem. I blocked off the large hose off the bottom on the stock bov and the just run the top hose on the hks, just wanting to know what else it could be?

Any help would be great.

Link to comment
https://www.sau.com.au/forums/topic/423847-hks-ssq-bov/
Share on other sites

it should make no difference if the valve is setup properly.. the spring tension must be set for the particular setup.

google setting up bov tips..

if you need some electronic management to run a bov it would be a flawed design.

IMO they are not a performance upgrade, they just make a girly sound and they are a defect worth defecting.

external gate + remove BOV.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/423847-hks-ssq-bov/#findComment-6821948
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sorry for reviving an old post, but I'm having the same hot idle tick issue. Did anyone ever find out what it was?  I have checked/ replaced Injectors Coils checked Lifter clerance (is at zero) Checked Cam lobes Replaced exhaust gasket and studs Would appreciate any advice this is driving me nuts  
    • There's a huge reason manufacturers are tuning in dead flat torque curves... Make them reliable (and more drive able)
    • What HVAC actuator is under the steering wheel? Do you mean on the RHS of the centre console, immediately to the left of your shin? If so, then yes, it is probably that one, because that is the mode door actuator, and from what I know, it's still a pain in the arse to replace. I don't know about whole dash out, but you certainly have to rip into the centre console section. I don't know if it's covered in the workshop manual, as I haven't spent much time looking at those parts of it. (and by "the workshop manual, I mean the R32 GTR one, which is the most comprehensive one we have, and it should be similar enough between that and later cars to serve as a guide).
    • ...oops. forgot the TCU end...
    • No I got mine from a friend that had fabricated one … but I had to fit it to my setup which was a hks turbo setup. His was a Garrett -7. So one of my turbos was not a flange for one side … then I had a leak in the welds I had to find a weld shut … in the end the setup was decent priced but I spent a lot to get it fitted. A couple companies I checked would make it but you’re talking 7-9k aud with titanium. No joke mine was 6-7k even second hand after I had to fit it in Hong Kong … labour is expensive here. 
×
×
  • Create New...