Jump to content
SAU Community

Recommended Posts

I set mine up yesterday, seems I missed setting it up correctly, when the card got full it just stopped recording.

Downloading the software now to see what the vids are like after I played with some settings to see if I can get auto deletion going.

will be interested in a 2nd group buy.

so, any night vid?

or track vid?

or track at night?

i have night vids tho yet to up them, there are a few settings all seem to change the quality/outlook

Edited by Frosty

I set mine up yesterday, seems I missed setting it up correctly, when the card got full it just stopped recording.

Downloading the software now to see what the vids are like after I played with some settings to see if I can get auto deletion going.

default setting is every 10mins a new file is written. Check in the software or look at the contents of card you will find files

Quality looks sweet. I'll be keen for the next group buy.

Did see a $60 special at jb's for a small similar unit. Have to see if it stacks up

Found it

http://www.jbhifionline.com.au/car-sound/car-accessories/uniden-vehicle-accident-camera-with-night-vision/684868

Can someone advise the benefits of the group buy unit over this? Keen ez

Edited by barraspalding

Read the review left on that link. Think that explains why this one is better :yes:

"Now the BAD: optics! The most important feature of any camera - quality of video recording. Picture is rich with colors, but sharpness is very low. Almost like out of focus. You can see the number plates only when right behind at the traffic lights. Up to 720p it is bearable with refresh rate (no specs on this) yet jerky with some fast movements around (turning). Above 720p is too jerky (too low refresh rate "

"Now the BAD: optics! The most important feature of any camera - quality of video recording. Picture is rich with colors, but sharpness is very low. Almost like out of focus. You can see the number plates only when right behind at the traffic lights. Up to 720p it is bearable with refresh rate (no specs on this) yet jerky with some fast movements around (turning). Above 720p is too jerky (too low refresh rate "

EDITED coz im a twit....hahaha

Edited by Frosty

Quality looks sweet. I'll be keen for the next group buy.

Did see a $60 special at jb's for a small similar unit. Have to see if it stacks up

Found it

http://www.jbhifionline.com.au/car-sound/car-accessories/uniden-vehicle-accident-camera-with-night-vision/684868

Can someone advise the benefits of the group buy unit over this? Keen ez

sinista has covered it from the reviews on JB

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • These are small points I should actually add to my original post. GKtech makes an extended slave line for this conversion. It's what I use, and it works well. You'll also need a CD009 slave cylinder.  S/R Chassis Z33/Z34 Conversion braided clutch line As for transmission sensors, you'll need to both extend the wiring and replace the connectors. I can't recall which is which, but one is your neutral switch and the other the reverse switch. As they are just switches, just test for continuity with your transmission in neutral or reverse to figure out which is which. Connectors:  VQ35 neutral Switch Connector | Wiring Specialties VQ35 Reverse Switch Connector | Wiring Specialties 
    • I’ll try and see it could be the release bearing. As for the 4th gear grind maybe clutch doesn’t disengage properly cause it is slightly like very slightly hard to go into first could be due to the slab cylinder pin being short uni clutch is a twin plate.   Ive attached some assembly photos hopefully you can open the link and see maybe detect what’s wrong https://share.icloud.com/photos/0dc2YvW__Hl6jl-l2_0jejjpg https://share.icloud.com/photos/09e0jkWOK-vP48c1cfY6u3ViA https://share.icloud.com/photos/0b4rDmh5R7pK7fb1VtND73a3g https://share.icloud.com/photos/05eeUi_6dC4DVi80jOUYDgb0g https://share.icloud.com/photos/06335TgY1XxyIJal_wkdQLhzw
    • Yeah for sure that is peddle adjustment 
    • What are your thoughts on this after having it for a while, worth getting?
    • Downshifts are harder on transmissions than upshifts, the input shaft naturally slows down once disconnected from the engine so the synchros aren't doing all the work. There's no "natural" tendency for an input shaft to increase RPM. Something is not right there, I don't have a great answer on what. You can try a dedicated GL4 75W90, I plan to switch to Motorcraft XT-M5-QS which is supposedly a very good 75W90 for NB Miatas which have a weirdly sensitive transmission from the factory. I would chase down why your clutch is making a hissing noise, that's not normal. It might be no big deal but in the absence of anything else to investigate I would look at that.
×
×
  • Create New...