Jump to content
SAU Community

Recommended Posts

Ey guys wrecking my s1 rb25det stagea it's a silver cor has teins all round spitfire coil packs twin sunroofs let me know what you guys need I'm located in melbourne east side car runs everything works 0401882730

Link to comment
https://www.sau.com.au/forums/topic/424995-wrecking-s1-awd-rb25det-stagea/
Share on other sites

Yes cup holders under head unit

Has blitz return flow intercooler kit $300

Power fc with hand controller 900 obo

Front end side skirts tail lights coilovers gone

What are you after nick88?

Hey Jet2NV,

Tried to send you a PM, but it won't go through, can you PM me a price on the RB25DET (Turbo not included) and also the shaft from Transfer case to the front diff and a price on the rear diff also?

Sunroofs going tomorrow for 500 unless better offer motor has gone to someone else

Cooler kit is complete feel free to text me 0401882730

Also has spitfire coil packs 350

Ark electronic boost controller 200

What power FC did you have running this? For a 33 or 34 and what m wiring mods to make it work and was it still auto??? Only asking out of interest coz pfc don't normally match up to s1 loom or auto

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I tried my best, well I see how it is though... It's time to be ruthless! I'll up my bid with a JVC sub and an amp to run it, 8 stainless steel drink coasters with a rubber backing, and a photo of Tom Cruise. Oh, I can increase the cash portion by 20 cents if that helps. 
    • Or if it's grey, is it watery? Does it do it after you've been for like an hour long drive it will still do it, or just near the start of the trip? As GTS said, does it seem like oil (blue), water (white/grey) or fuel (black)? Sometimes the colour can be hard to see clearly too for what it is, as GTS says, what's it smell like?
    • I wonder if part of it has to do with when you've each bought the kits. I honestly have the feeling that the silicon joiners in the 2000s were actually better quality than most of what you can find these days. Even in the same brands. Everyone racing to the cheapest price while still trying to make profit means lower quality parts. For coolant, I personally would be going with rubber, OR, converting the radiator and engine to use the huge AN fittings hose for radiators.
    • If shift solenoid A is bad, that explains limp mode --- now you're in the same position as I mentioned previously, in that the next step is to confirm loom/wiring integrity from TCU to gearbox connector with a multimeter (the TCU cannot detect a broken wire, which can happen ..ie; rodent damage, loom rubbed through)...and then finally measure resistance (at the gearbox connector) for shift solenoid A ... ...once you confirm shift solenoid A is bad (open circuit, really low or greater than 40ohm resistance), then it's a job ; you have buy a complete solenoid set, get under the car and drop transmission oil pan, and remove valvebody assembly (the solenoids sit on top), replace solenoid set, and reassemble....it's not exactly a fun task, but readily doable.
    • Is it oil smoke or fuel smoke? They smell different.
×
×
  • Create New...