Indicators Not Working

[Aiden]

Hi All,

I did a sub install last night and all was running fine until this morning I went to leave for work and my indicators won't work.

when i move the lever it does not display anything on the dash, or make the "tick-tock" noise. however when hazards are pressed in all works fine?

i have checked the fuse and replaced it with the spare, problem still persists. Upon researching i have heard this may be caused by the indicator stalk having worn contact points.

has anybody experienced this or had similar issues?

[R.3.2.G.T.R]

still sounds like a fuse problem, did u check all the fuses in the fuse compartment? i think hazard circuit is a lil different to indicators but not a 100% on that

[Aiden]

still sounds like a fuse problem, did u check all the fuses in the fuse compartment? i think hazard circuit is a lil different to indicators but not a 100% on that

I'll have a look now and see what i can find.

[Aiden]

still sounds like a fuse problem, did u check all the fuses in the fuse compartment? i think hazard circuit is a lil different to indicators but not a 100% on that

I'll have a look now and see what i can find.

i have taken all fuses under the dash out and they all appear to be intact, i have put them all back in and same problem persists.

[Aiden]

This has been fixed, one of the pins that your hazard connection plug into was bent down. A careful bend back and it was working perfect

Picture of plug with pins.

http://auctions.c.yimg.jp/img379.auctions.yahoo.co.jp/users/8/2/1/9/nono180sx-img600x432-1349793910ovkykl48798.jpg