Jump to content
SAU Community

Recommended Posts

Hey guys I have an R34 GTT coupe automatic. Was just wondering what you guys use/prefer as engine, power steering, transmission oils (brand/type) etc

I am curious as to what you guys think is best. The car goes through periods of everyday use and also theres times where it doesn't get driven for a week or so.

Also any other general tips for good maintenance (like letting the car warm up in the morning etc) would be great!

Thanks!

Josh

Link to comment
https://www.sau.com.au/forums/topic/426903-oil-types-maintenance/
Share on other sites

Personally I only use Royal Purple 10w40 engine oil, but that's just a personal thing. Lots of guys using Penrite, Motul, Gulf Western, etc. Weight of the oil you use depends on how many km's your engine has on it. Power steering I just use the OEM Nissan stuff, and I've got a manual gearbox so can't help you with transmission fluid.

As for maintenance, not a lot you need to do other than check fluid levels etc. every so while. The car should be fine sitting for a week or two, mine sits for months at a time haha. If it is going to be sitting for longer than two weeks without getting a decent drive, I recommend getting a 3-stage battery charger to ensure you get a good life out of your battery.

Don't let the car warm up in the morning by letting it idle, that's silly. It takes longer for the engine to warm up this way, and you need to warm up your gearbox and diff anyway. Plus you annoy your neighbors. Just drive the car gently for the first 10-15 minutes or so, depending on how cold it is. If you plan on doing some track work at any stage, some gauges (water/oil temp, oil pressure, etc.) wouldn't go astray and I find mine extremely useful. Otherwise, just drive the car like you would any other car, and service it regularly :thumbsup:

Edited by Hanaldo

Don't let the car warm up in the morning by letting it idle, that's silly. It takes longer for the engine to warm up this way, and you need to warm up your gearbox and diff anyway. Plus you annoy your neighbors.

+ your family, if your car is parked at the front of the house where the bedrooms are hahaha but i always find it amusing

  • 2 weeks later...

With warming up the engine. I would say to let it sit for a minute or two after startup so oil pressure builds, coolant can circulate, etc. Like not driving it immediately after the engine starts.

Oil I would say a decent 10W-40 is fine. Nothing super cheap, but you don't have to go super expensive either. Used Nulon Full Synthetic10W-40 previously and just put in Penrite 10 Tenths 10w-40, Penrite is not giving any lifter noise on startup whereas had some noise for a few seconds with the Nulon. Slightly thicker if the engine is older/using a lot of oil or used for track.

1 for Penrite

Warm up times is subject to much debate, lol.

As the guys have said, give it a minute or two to get some oil pressure, but also ease the box and diff in as well.

When I was daily-ing my Cefiro, I'd start the car, chuck my bag, phone, wallet etc on passenger seat, jump in, find some tunes/check Facebook, that'd kill about a minute or so, then roll it out the driveway, pop it into second and idle down my street (about 100-200 metres @ 20-30ish kmph??), then be gentle and stick below 2500rpm for the next couple of backstreets, then keep it under 4000rpm, then by the time I hit the highway it was up to temp.

Edited by Nic_A31

Mine takes ages to hit temp even while driving. Like i'm talking a good 15mins+. I think the thermostat may need replacing.

TBH, I usually warm the engine up to about 40-50 degrees with some throttle blips every couple mins before taking off. Take it easy, like no positive boost and <3000rpm, until oil pressure drops so i know oil is up to temp.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Here's one I help build and tuned a decade ago, Garrett  GTX3071R Gen 1, T3 twin scroll 0.83 rear housing. Went from larger 272 cams down to smaller Tomei Poncams to help with the low end. S13 non VCT motor. Car was purpose built for the track, hence low down was the focus. Note the actual dyno chart shows lower boost, however the EBC and boost gauge showed 1.9Bar (Ignore the torque, I was young and didn't know how to set derived torque)  
    • I’m doing some side developments on SR20det S13 engines, its one my hobby cars used it to compare flow capacity of some smaller size wheels. SR20det is one of another JDM legendary engines I'm sure there are plenty of SR enthusiasts on this forum, I will share results some common turbo configurations here. a quick run down of what the car is: Wide body 180sx Type X with black top engine (blue). It has: Stock bottom end Haltech 1500 ECU 5-0 motorsports trigger kit Kelford SR20DET Beehive Spring with Titanium Retainers Kelford Cams SR20DET S13 188-B 268/272 Cams G25-660 Turbocharger in T2 .64 rear housing internally gated ARP Head studs MLS head gasket 1000CC ID injectors Walbro 450L Fuel pump Front mount cooler kit JJR’s 3 inches turbo back exhaust (its too short for the 180sx it had to be extended) Pump 98 fuel Hub Dyno tune So far made 270rwkws at 22psi full boost by 4500RPM. Engine is very knock limited hence a pretty bad looking top end. From previous experiences it seems like SR20dets are happier with bigger size turbine, some thing like a GT30 would make way better top end, but on same time response is lost. It won't be a problem with S15 VCT engines. I'll be testing alternative turbine housing, turbine wheel and possibly dump pipe options for extra flow to resolve the problem and of course E85 would resolve all the issues.            
    • Awesome writeup and details. Thanks for sharing the story so far. I can relate to parts of it with my previous car and some of the issues I had to deal with.
    • Wow the colour matched hard top completely transforms the car. Are there any nice front lip options for the car or is that off the table?
    • Generally yes but for some reason I've been ruthless this time around!  I might even need to do another tip run after the way I've finally been able to hit the delete button on shit I've stepped over, stepped around and tripped over for the past 10 years!
×
×
  • Create New...