help with blitz boost control id3

[MR R33 GTST]

Hi all i just add my new ebc installed but it is set to 10psi but in first gear it wont boost over 7 then as the gears change the boost comes on more and more can any one tell me what the problem could be ? i used to have just a bleed value and soon as i put my foot down it would give me 10psi but this one is like its restricted if anyone knows how to use a blitz id boost control please help !! or if any one has one i need help thanks all !

[mist]

i've got the D1 Blitz/URAS edition, should be same functionality wise. Can you give more details re. ur boost settings? i.e. auto/manual, gain, etc...

[MR R33 GTST]

the boost is set to 9 psi gain is on 7 and it is psi cause i changed the unit it was in thats realy all i know about it and its auto

[mist]

ok, since the unit is set in auto, it's trying to learn I think. when you first set a boost setting, and then go out for a blat, first gear is usually ok / below what u set, then as the load increases (keep your foot flat on the gas, not part throttle acceleration), the unit may overboost, sometimes by a lot (if the gain setting is increased). watch the boost carefully, once it goes past your boost setting with ur foot flat, take your foot off the pedal - turning on the warning function - limiter - would help prevent any damage from overboosting. on the next time you start your car, the boost should be fine, go straight to your setting and hold. thats how i 'taught' the unit on auto mode. better to use the manual mode tho, especially if you plan to run more boost.