Jump to content
SAU Community

Recommended Posts

Hi guys I'm a bit confused on what oil to run in my gtr been told castrol edge is good but then I found that there is castrol edge sport as well witch cost a lot more $$$$$$$ what are u guys using can anyone help me out on this or is there a better option to go with thanks guys

Link to comment
https://www.sau.com.au/forums/topic/428108-is-it-castrol-edge-or-edge-sport/
Share on other sites

pretty sure it's the sport.

If you're running E85 i believe edge sport is the one you should really run (SN spec), otherwise i don't think it matters too much as long as you have the correct weight/viscosity.

Given your username and you said GTR, i'd go with the 10w60 Edge.

mmmm I don't use castrol so I can't distinguish between the two. but you don't wanna cut corners on oil.

For what its worth I only put Motul in my car, its int the same ~$80/5L price bracket unless you get the 300V variant.

Use royal purple 10/40 the best

Don't know whats best man!!

I used that exact one, was told to change to edge as oil pressure wasn't high enough or something like that during dyno tuning, this was years ago now can't exactky remember. I'm not saying this is the best, it's just what iv been advised to use by my workshop for gtr's. There's definitely lots of oils to choose from, don't wanna turn this into an oil debate, plenty of those on this forum.

Don't know whats best man!!

I used that exact one, was told to change to edge as oil pressure wasn't high enough or something like that during dyno tuning, this was years ago now can't exactky remember. I'm not saying this is the best, it's just what iv been advised to use by my workshop for gtr's. There's definitely lots of oils to choose from, don't wanna turn this into an oil debate, plenty of those on this forum.

Cause it's what Racepace said yeah :laugh:

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m also conscious that e85 is slowly being phased out. Not all United’s have them anymore. Can’t take the risk of being low on petrol and assuming the servo will have it. 
    • MR HAMMER has said his piece. Painted up to avoid Rusty Rusty. Actually lines up well. (i.e it lines up the same as the unmolested GTR guard). Turns out the GTR Strut brace does foul on the bonnet vents ever so slightly. May need a little bendy bendy if intended to keep using with a strut brace. So spacing it out to clear the FAST102 is not an option. Annoyingly, the bonnet vents also foul on the heater lines running over the engine. Given this engine does not EVER require a heater, a delete loop is going to be used. Don't worry, the defogger uses the AC. The heater is basically "Do not use the aircon and turn the fan on". It will still be effective, I promise.... once I get the system regassed... Will have to revisit with unvented bonnet I suppose, and suitable strut brace. There's plans to do this and other things tonight and bleed brakes (there was a weep) and put the bumper back on, and take Good Friday morning - Because troubleshooting on the side of the road limping it home at midnight tonight is ... not very smart.
    • Thank you all for you assistance. I contacted Nistune regarding the support for the RB20DE along with my ECU Code (23710-10U00). They do have a map for it and added the RB20DE as a purchasable option now as well. They also added Malta as a Billing and Delivery options as this was missing. I was honestly amazed at their quick response and action, it took less than 24 hours. I also looked again at direct fit options for injectors, just in case I were to replace them. DeatschWerks seem to use a Bosch EV14 base and makes ones that fit mine at 440cc lowest, but also have 550cc at the same price. I tried looking for other direct fit options and managed to find one (also Bosch EV14 based) which includes a plug and play adapter on ebay. Did a small test with a Noid Light on the troubled injectors and all seems good, so they are pulsing properly electrically. One weird part is that they are missing on the same two cylinders as before I got the injectors cleaned. Mechanic also found this weird as he did not label the injectors and it is unlikely to have the faulty injectors be installed in the same cylinders.  
    • Nice, let me know how you find the 98 tune
×
×
  • Create New...