Jump to content
SAU Community

Recommended Posts

Hey guys just looking for some advice from you guys who have more experience in these vehicles than I do.

I have a budget of about 4k to spend on my vehicle but want to spend it wisely and with the most reputable people as in workshops, tuners etc.

Car is: r34 gtt sedan manual

3"exhaust turbo to rear

Rfmic

Bc coilovers

Split fires

About to install walbro pump

K&n panel filter

Any help, links or suggested contacts would be awesome. Don't know if to get nistune board or power fc.

Regards,

Rob

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/
Share on other sites

For a $4000 budget and your current mods, I'd be getting an ECU, Highflow R34 Turbo, Z32 Air Flow Meter and a Tune should bring you to about 250-260rwkw.

ECU and Tune only will be about $900 - $1000 and you might get 180-190rwkw or so?

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954263
Share on other sites

For a $4000 budget and your current mods, I'd be getting an ECU, Highflow R34 Turbo, Z32 Air Flow Meter and a Tune should bring you to about 250-260rwkw.

ECU and Tune only will be about $900 - $1000 and you might get 180-190rwkw or so?

i

Ok so ill order a z32 Afm now... What turbos do u suggest? Also what ecu?

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954272
Share on other sites

Remember that you'll need the Plug for the Z32 as well, so it can wire straight up.

I've got a 33 and put an R34 Highflow Turbo on it... If you send off your current turbo to Stao from Hypergear he can highflow it for you, changes all the internals of it to steel wheels etc which can support a lot more boost than the standard one, and machines out the housing so it flows a lot more air.

I run a PowerFC with a hand controller, cost me about $1k, plus $500 or so for the initial base tune then a power tune... retunes afterwards are charged per hour.. so only end up being $150-200 or so for little changes.
Nistune is a daughterboard which connects into your existing ECU, its cheaper and retains the standard ecu which is good in some ways... as mentioned above, you can get one supplied, fitted and tuned for under a grand.

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954294
Share on other sites

Remember that you'll need the Plug for the Z32 as well, so it can wire straight up.

I've got a 33 and put an R34 Highflow Turbo on it... If you send off your current turbo to Stao from Hypergear he can highflow it for you, changes all the internals of it to steel wheels etc which can support a lot more boost than the standard one, and machines out the housing so it flows a lot more air.

I run a PowerFC with a hand controller, cost me about $1k, plus $500 or so for the initial base tune then a power tune... retunes afterwards are charged per hour.. so only end up being $150-200 or so for little changes.

Nistune is a daughterboard which connects into your existing ECU, its cheaper and retains the standard ecu which is good in some ways... as mentioned above, you can get one supplied, fitted and tuned for under a grand.

Ok so what is better though cuz I'm searching all over this forum I can't find any answers, power fc or nistune? And thank you heaps for ur info mate

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954317
Share on other sites

Chequered Tuning - 110%

How often/much do you drive your car.

I'd seriously consider getting a Hypergear turbo as well.

As for ECU's, i think Trent would pick the Nistune over the FC for a GT-T - but i'd be seriously looking at the offerings from Link/Vipec/Haltech as well. Not up-to-date about who offers what for the GT-T. Best to check this with Trent.

If you went with a newer ECU, you'd be running MAP sensor, so don't need a Z32 - but will if running Nistune and a bigger turbo.

Add some whiteline adjustable swaybars into your budget as well.

You'll need some injectors too. What Walbro you get?

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954329
Share on other sites

Chequered Tuning - 110%

How often/much do you drive your car.

I'd seriously consider getting a Hypergear turbo as well.

As for ECU's, i think Trent would pick the Nistune over the FC for a GT-T - but i'd be seriously looking at the offerings from Link/Vipec/Haltech as well. Not up-to-date about who offers what for the GT-T. Best to check this with Trent.

If you went with a newer ECU, you'd be running MAP sensor, so don't need a Z32 - but will if running Nistune and a bigger turbo.

Add some whiteline adjustable swaybars into your budget as well.

You'll need some injectors too. What Walbro you get?

Who is chequered tuning....? Never heard of them. Walbro 255lph intank.

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954332
Share on other sites

Who is chequered tuning....? Never heard of them. Walbro 255lph intank.

Trent and Cat run Chequered Tuning, they're damn good at what they do. They're located in Keysborough and really know their stuff. Sometimes their a little hard to get a hold of, but leave a message with Cat and she'll get back to you.

http://www.chequeredtuning.com/

Best to talk to Trent first about your budget and goals, I'd hold off on getting that Z32 for now, SS8_Gohan is right, you might be better off running a MAP (Mass Air Pressure) sensor instead of a MAF (Mass Air Flow)

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954637
Share on other sites

May b on the weekends so prob lucky to do half a tank of fuel a month may be a bit more in summer

good answer

E85 time!! :D

You could go flex fuel for not much more, would fit in your budget. Or just full time E85 considering how much you drive it.

Madness not too.

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954874
Share on other sites

good answer

E85 time!! :D

You could go flex fuel for not much more, would fit in your budget. Or just full time E85 considering how much you drive it.

Madness not too.

Lol u have my attention... Please go on, who's the best to go and see about this

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6954877
Share on other sites

Trent's the best to go to see for tuning... anything, unless it's a wolf :D

Go to unitedpetroleum.com.au or unitedpetrol.com.au - search for just 'E85' and see how the locations of those servos work for you.

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6955317
Share on other sites

Hey guys

Don't really no if this is on the same topic or not but

just wanted to no if anyone on here has had any trouble

with a R34 sedan doors not all locking, when unlocking/locking

it up ?

If anyone one knows what could be the problem please PM me or email me.

Thanks.

Link to comment
https://www.sau.com.au/forums/topic/429677-need-advice-r34/#findComment-6964562
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The cam I am actually putting in (a few posts up) is actually smaller than my current one. At least duration/overlap wise. All the chop stuff I hear just sounds like an engine running badly, because it is. I then envision driving it around in 1st gear and being massively sad about it bucking to the beat of said chop. There is an idle video of someone with a similar cam floating around the internet, but mine is a custom cam (so is his) so it'll never be the same, plus the fact exhausts are entirely different. What I want to do is put some bullet mufflers/race mufflers in to replace a couple sections straight pipes that currently replace the two extra cats that I don't need. But this is even further down the line!
    • I can tell you now, when the bracket that the little hydraulic ram attaches to snaps, with a subframe, and V8 from an AMG C63 on it, it sounds like someone letting shotgun off right beside you. It leaves your ears ringing, and a huge thankfulness that you never ever put a body part under something heavy that's only supported by a hydraulic lift...
    • Still not a guarantee fix. I used a high quality butyl-mastiq (the black goo that's not really silicone nor polyurethane, same stuff they use from the factory that just spreads out like melty cheese), and I still get lots of water on both sides of the trunk when raining or washing the car. I also suspect the factory spoiler rubber gasket might not be sealing well, so I'm thinking of adding a thin layer of grey silicone around the bolt holes on both sides and see if that's where it also leaks from. The biggest issue is that these cars don't come with a drain hole on each side like other coupes and hatchbacks.
×
×
  • Create New...