Jump to content
SAU Community

Recommended Posts

I've read this threat with interest - great stuff!!

In regards to this 'bucking', my 2007 V36 Coupe does something really annoying that sounds similar. It's like it 'lunges' or lurches forward as I'm slowing down, especially noticible (and dangerous!) as I'm slowing down to stop at a set of lights. It's as if there is some problem with the rev-down shifting as the auto drops down through the gears. I swear I'm going to rear end a car if I'm not careful!! In fact, bucking is an excellent way to describe it as it's like I'm riding a horse that is about to launch into a gallop (whilst I am trying to slow down and stop!!).

Is this the same thing?

My problems have only been with acceleration. I did have what you might call a lurching problem due to rough down shifts, felts like it was shifting down at high rev's, and the lower gear was given too much power. But it never altered my speed or made it difficult to control. It was more of a single jolt which it would also do when accelerating after letting the car roll for a bit. For me after updating, that problem is mostly gone.

Perhaps your problem is something else.
A while back I had a Auto Holden Calibra, i swear this thing was haunted and trying to kill me. I would slow down to stop at lights and it would all of a sudden rev up and send the car off at 80kmph! I ran so many red lights.
Turned out it had a blocked Idle Control Switch (little valve controlling air flow during idle) 2 cans of degreaser later and I had purged the demon..

  • 3 weeks later...

Just read the thread, man what a friggn journey you'v had. It all comes down to a firmware update.

Me 350Z '06 revup 6MT . When i bought it it dint have the missing you had, mine had terrible pinging at those rev points you talk about. Nissan dealership had no idea. Nissan OZ no idea , no help whatsoever.

So i went to a local guy in Silverwater- SAS. Dave had worked out code and was able to retune . I had a few goodies put on and the outcome was really good.

So it took a custom remap on the dyno to fix. The issue- the exhaust and the changing between certain loop things was causing the lean outs.

Any way my zee is running really sweet ( HKS S/C added )

NISSAN AUSTRALIA!!! WAKE UP WE ARE NOT STOOPID , LOOK AFTER YOUR CUSTOMERS

  • 1 month later...

So I've just had a read of this. Interesting feedback on what you experienced. I feel similar 'glitches' to everything you've mentioned, but noticed it only does it in Drive. Switching to DS (Sport) eliminates these issues, which leads me to the possibility of it being gearbox related, not engine. The idle between 1000-2000rpm feels more like the clutch kicking in, cause if you hit the gas when you feel one of these 'idle' rev moments you get a very gradual bite.

But of course, if it is just a gearbox calibration issue you've got to wonder why Nissan would have let it go out like this in the first place. So then you'd start to consider climate being an issue, sensors being calibrated to typical Japanese weather conditions rather than Australia's dusty humid mash-up.

Either way, most of what you've said sounds more like gearbox, clutch, and flywheel. I'd love to know what the firmware update 'Patch Notes' say.

Chris Rogers, saw you piping in earlier. If we can get our hands on that firmware update is that something you can update for SEQ based owners, or do you know of a preferred Nissan service centre?

Edited by Simink

No clue what the patch notes are, the infiniti site might have some info on it.

I know there were two seperate updates consolidated into one, a ECU update and a Transmission update. The latter specifically for hard up/down shifts.
My issue was subtle for months, like you describe a very small bite. It eventually escalated.

Nissan GTR centers will have the update done remotely for you.

My pv36 is yet to have any problems since updating.

Nissan GTR centers will have the update done remotely for you.

When you say remotely, do you mean they use a local third party service centre - so they don't cop the shit if it goes wrong (or just not allowed to update with Inifiniti branded firmware - internal red tape)?

If it gets worse over time the firmware update (I can only assume) stops some of the live-calibration in the ECU. I hate when they update shit like this without telling you what it is.

When you say remotely, do you mean they use a local third party service centre - so they don't cop the shit if it goes wrong (or just not allowed to update with Inifiniti branded firmware - internal red tape)?

If it gets worse over time the firmware update (I can only assume) stops some of the live-calibration in the ECU. I hate when they update shit like this without telling you what it is.

Nissan plug your car into their comp, and someone at TechLine in Syd applies and configures the update. Nissan does not provide this update file to it's service centers, remote only.

Innitially I was told they would have the file in hand, but there was no warranty or guarantee my car would even start. I guess someone a little higher up decided that was probably going to get them into trouble.

The ECU still learns, and power is very slightly reduced. Today in this lovely Adelaide rain I also discovered the anti slip is not as full on ;)

  • 4 weeks later...

I ended up importing a 2009 370GT (still waiting for compliance!) so fingers crossed it doesn't have these issues...

I've had my 2009 since the beginning of 2012 and have not experienced any of those issues. I'd say you're safe.

  • 3 months later...
  • 2 months later...

I may have felt something similar, like I was braking and I thought I felt the car jump a little forward before stopping completely

Not sure if it was me or the car...guess I'll find out after driving it a bit longer

Would a custom dyno tune fix any throttle problems too?

I wouldn't call the 370GT the smoothest car ever but for the luxury and performance I'm very happy

I still have this problem even after I cleaned my MAF. Fuel economy did improve though (which was great), but bucking still present. I suspect it's a gearbox thing and will ask my mechanic to look at it at my upcoming service. Hopefully it's just the gearbox needing an oil change.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
    • So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
×
×
  • Create New...