Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

sup f**kers, car is serviced but is missing at 4-5k rev's. Engine is cold though. I will take it for a drive and put some good fuel in it tomorrow if it is still crap I will put the old plugs back in

Coils

Possibly, could be loom.

Yellow jackets with around 20,000 on them

Car was running perfect before plug swap so I can always put the old ones back in and see if it is the issue.

sup f**kers, car is serviced but is missing at 4-5k rev's. Engine is cold though. I will take it for a drive and put some good fuel in it tomorrow if it is still crap I will put the old plugs back in

any gapping in plugs Clint!

Possibly, could be loom.

Yellow jackets with around 20,000 on them

Car was running perfect before plug swap so I can always put the old ones back in and see if it is the issue.

can also be the simple case of not torquing the plugs down correctly when reinstalling them

Coils.. but make sure you have ever thing plugged in firmly. Before buying new coils tape them up as much as possible and see if that fixes the issues, I did this and it lasted 2 years before I decided to buy new splitfires

u r tougher than that and u know it mate.

If people do put you down tell them to F off bro!

I just don't like the typical gym douche that love in there... So, I lift at home lol

I just don't like the typical gym douche that love in there... So, I lift at home lol

I know what u mean. But sometimes it's a good laugh to look at the Johnny Bravos strut their stuff lol

I am going to go over it again tomorrow, all plugs are gaped @ .8 5 are bcpr7es and 1 is a bcpr7es-11 (gaped to .8) can't find a 6th bcpr7es anywhere up here.

I will inspect the coils again tomorrow as well as the loom.

I will swap the gaped down one out first and see if that fixes it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...