Jump to content
SAU Community

Events

Aurora

By Aurora,
in Australian Capital Territory

 Share

Recommended Posts

Tosh Grand Master

Tosh

Posted
Posted
it's a bit hit and miss sometimes, organising cruises here :)

a few years back (when we were all over at skylinesdownunder.com) we had some good cruises, like to the Cotter (our first ever one) which had a pretty good turnout. We also had a Batemans Bay one which was great, and then when we started these forums i organised one to Kangaroo Valley with the Sydney guys and it was awesome!! But there was ones inbetween that had a dismal turnout..

I've been so unmotivated to bother organising anything lately, and i used to be the motivating everyone else lol

anyway, I'd be keen to do a food/coffee/beer type thing in the afternoon or one night... While the longer cruises are fun, I just can't get my arse out of bed these days to do a Bay cruise or similar due to working late hours.

That's because your lazy shelly dear...

you guys should organise to do joint crusies with Shogun.

Goran (whytry) will tell you as well that they hold alot of events and they're cruises are always good fun... (until someone's clutch starts slipping while doing high speed runs :))

Link to comment
https://www.sau.com.au/forums/topic/43127-events/page/2/#findComment-884326
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTR ZOAH
      S A U N S W Club Membership

      By GTR ZOAH · Posted

      I'm finally back people!
    • Lithium
      Compressor flow comparison table

      By Lithium · Posted

      On the compressor side it looks like the best, if your head setup will support doing 100-110lb/min at 30psi-ish boost.   The G45-1350 compressor looks ideally better if you need closer to 40psi for it, given both the G40 1150 and G42 1200 look like they'll be around the 100lb/min mark at 35psi and dropping from there.   Bear in mind the turbine sides are all different between those three turbos, so that COULD be an influencing factor for how they all perform in the real world as well.   Not sure if you've made a conscious decision to only look at Garrett or not, but at least on paper the XRE7169S matches or beats those other three at everything from 30psi up and just going from wheel size alone likely to be at least as responsive as the G40 1150 and seem to behave closer to G42s in terms of turbine flow.
    • Butters
      Compressor flow comparison table

      By Butters · Posted

      @Lithium  looking for a turbo for my Rb30. Want to make sure I understand this correctly.   If I want to stay 40psi or under my best choice of these 3 is actually the smaller G40-1150 ?
    • PranK
      My BMW E39 528i touring

      By PranK · Posted

      Massive ups for MTHire also. Could not have done the subframe bushings job without hiring the tool from them. Process was super easy and cost me around 25% of the cost of the tool. If you need a tool to do a one-time job, check them out. (Paid for the rental myself, no sponsorship here.)  
    • Duncan
      I need more than help to finish my R33

      By Duncan · Posted

      I'd suggest calling Unigroup, they have a lot of experience with these, access to reliable fabricators etc. Of course it will cost but at least you can trust what they tell you
×
×
  • Create New...