Jump to content
SAU Community

Recommended Posts

Hi guys and girls, anyone have any ideas what could be causing my stagea to run rough? Sounds like it's running on 5 but tacho says it idles steady, it still makes boost but slowly, feels like it goes good once the boost kicks in. Just changed the plugs and coilpacks and all the plugs look the same, no fouling etc. Wondering if it could be fuel filter or boost leak or afms, or fpr? Just had fuel pump done too. Also has a bit of backfire on gear changes

Link to comment
https://www.sau.com.au/forums/topic/432543-help-rb26-sounds-like-a-wrx/
Share on other sites

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

  • 1 month later...

Ok guys, replaced the plugs, replaced the packs with splitfires and just put in a new coilpack loom, still sounds like it's missing and smells rich plus is very laggy and won't make full boost, could it be an injector?

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

Did you do this? Or just replaced stuff for fun? Narrowing it down to a cylinder would have helped you determine if it was a coil pretty easily.

I replaced things that seem to cause common problems so I don't have to worry about it again for a while. It used to come and go so I had ruled out mechanical problems as I would think damaged piston or cylinder would be more permanent.

If it is intermittent there is a good chance one or both of the AFM's needs re-soldering, there is a 'how to' around on fixing them if you do a search.

It could be an injector too, would be a good idea to get them cleaned and flow tested just to rule them out.

I was just pointing out that trying to diagnose such problems over the net is near futile. It always turns out to be something either very obvious or nothing that anyone thought of.

So tempted to put that in my signature.
  • Like 1

When I bought it they did a compression test and has only done about 5000k since then so no I haven't plus cause it was come and go I didn't think it could be that. Happened around when the alarm went in, imobiliser issue maybe?

Wouldn't surprise me if its an afm.

Another quick thing to do would be check over all of the I/C piping and joiners for a leak and vacuum lines too

Edited by Even_Flow

Pull injector plugs one by one until one doesn't make it any worse than it is already. Once you find the cylinder that is missing check the plugs/coils/loom for that cylinder.

Could even use a screwdriver to the ear to find which one is missing.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You know, that is exactly the thing that I was thinking a coupe of hours ago. I even had a plan for a meme, involving one big one, another big one, and the Old El Paso girl saying "¿por que no los dos?"
    • NoS, 2 of the big ones.
    • Oh, that's grim. Something bad has been happening there.
    • Put an endoscope down the hole and saw this. Not quite all around the bore but a good 60% at least. Chin to the chest and towards further disappointments I guess.
    • 2 does "sort of" applies, maybe......but looking at what parts would be needed for the swap to get engineered, registered, and insured, and basically that's everything under the car, the modifications the make it legal would be problematic and horrendously expensive, all for a street car that just cruises around and hits a few twisty roads on the weekends Also, from looking at the NSW rules and Regs, with all modifications that is required just to make the car safe and not twist itself to pieces, and then actually get registered for street use, may still be impossible nowadays As for 1, when you add in a fresh engine, fresh transmission, rear cradle and diff, tailshaft, suspension, brakes, cooling, and all the other fabrication required, your probably looking at up to $100k to do it right, all for a 20 year old MX5 that is over engineered and you would never be able to actually use the power it has on the street, much like your beastie, which I love, but you actually track that thing and can use all of its powers in anger, in a safe environment  Hell, the old Bogan Cruise Ship had more power than I could use on the street, and in hindsight, I went a bit silly on that thing, it didn't really need the 500hp it had for what I actually used the car for, it was fun, but basically unusable on the street if you value your licence  As for cams, yeah, I'll probably book it in for them to get installed and tuned soonish, like next month after MX5 Mania are back at work....... and yes, I've already sent a email to bin the turbo quote and quote instead to install cams and a new Fluidampr balancer that will suit the 2.5 better than the OEM 2.0 balancer that is swapped over for the 2.5 install, as the balancer needs to get pulled to time the cams it's a while your in there sort of thing I did think a bit about flex fuel for a laugh, but being na, and no where really around locally anymore to get E85, I've binned that idea, so no sweet sweet corn smells are set for the car I wish E85 was more of a standard fuel, it's better for the environment, better for tuning, plus that sweet sweet smell we all love As for fitting in the family, that's not needed, as everyone in the family already owns a car that can seat 5 humans comfortably enough, the MX5 is "my toy" As for buying a car that is already built, nah, I would rather pick and choose my parts, I enjoy the process, and in the big picture, the additional cost is well worth the enjoyment, and the occasional frustration, I get out of doing it, albeit with other people spinning the spanners, and me, just paying the invoice 🤣
×
×
  • Create New...