Jump to content
SAU Community

Help, Rb26 Sounds Like A Wrx

autechwgn

By autechwgn,
in Engines & Forced Induction

 Share

Recommended Posts

autechwgn Apprentice

autechwgn

Posted
Posted

Hi guys and girls, anyone have any ideas what could be causing my stagea to run rough? Sounds like it's running on 5 but tacho says it idles steady, it still makes boost but slowly, feels like it goes good once the boost kicks in. Just changed the plugs and coilpacks and all the plugs look the same, no fouling etc. Wondering if it could be fuel filter or boost leak or afms, or fpr? Just had fuel pump done too. Also has a bit of backfire on gear changes

Link to comment
Share on other sites
Ben C34 Grand Master

Ben C34

Posted
Posted

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

Link to comment
Share on other sites
  • 1 month later...
autechwgn Apprentice

autechwgn

Posted
  • Author
Posted

Ok guys, replaced the plugs, replaced the packs with splitfires and just put in a new coilpack loom, still sounds like it's missing and smells rich plus is very laggy and won't make full boost, could it be an injector?

Link to comment
Share on other sites
Ben C34 Grand Master

Ben C34

Posted
Posted

Just because the tacho is stable doesn't rule out a cylinder missing. With car running disconnect one coil pack at a time, in no time you will know which pack/plug/part of loom is dodgy

Did you do this? Or just replaced stuff for fun? Narrowing it down to a cylinder would have helped you determine if it was a coil pretty easily.
Link to comment
Share on other sites
autechwgn Apprentice

autechwgn

Posted
  • Author
Posted

I replaced things that seem to cause common problems so I don't have to worry about it again for a while. It used to come and go so I had ruled out mechanical problems as I would think damaged piston or cylinder would be more permanent.

Link to comment
Share on other sites
scotty nm35 Grand Master

scotty nm35

Posted
Posted

If it is intermittent there is a good chance one or both of the AFM's needs re-soldering, there is a 'how to' around on fixing them if you do a search.

It could be an injector too, would be a good idea to get them cleaned and flow tested just to rule them out.

Link to comment
Share on other sites
Ben C34 Grand Master

Ben C34

Posted
Posted

I was just pointing out that trying to diagnose such problems over the net is near futile. It always turns out to be something either very obvious or nothing that anyone thought of.

So tempted to put that in my signature.
  • Like 1
Link to comment
Share on other sites
autechwgn Apprentice

autechwgn

Posted
  • Author
Posted

When I bought it they did a compression test and has only done about 5000k since then so no I haven't plus cause it was come and go I didn't think it could be that. Happened around when the alarm went in, imobiliser issue maybe?

Link to comment
Share on other sites
Rolls Grand Master

Rolls

Posted
Posted

Pull injector plugs one by one until one doesn't make it any worse than it is already. Once you find the cylinder that is missing check the plugs/coils/loom for that cylinder.

Could even use a screwdriver to the ear to find which one is missing.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • sonicii
      2020 Nissan Skyline 400R V37/Infiniti Q50 RS insurance in NSW

      By sonicii · Posted

      As far as I know, Infiniti stopped importing vehicles before 2020, even though they were still selling their stock for at least a year or 2 after that, they were older build years, therefore, you can import a 2020 400R, because you couldn't buy an AuDM 2020 built Q50 RS. As for insurance, you might need to go through one of the enthusiast insurance companies, they tend to insure a lot more grey import models than the mainstream insurers as Duncan mentioned.
    • araiko
      Importing from the US into W.A - 15 yo old car

      By araiko · Posted

      loved seeing the zenvo on the a1 just after the hatfield tunnel i was the guy in the white van trying to egg you on it sounded awesome and those exhausts glowing red inside insane cheers for the thumbs up tim and tom.
    • DraftySquash
      Question about R34 GTT A/T Solenoids

      By DraftySquash · Posted

      So.... when I'm finally getting around to having my power steering leak sorted, now it looks like I've got the same issue most A/T Skylines are having. My A/T light will randomly come on and I'm stuck in 3rd gear until I turn the car off and on again. Only 3 weeks ago I did a complete transmission service: Oil flush + new gasket + new filter. This came out of nowhere!! It wasn't like the car was driven hard. I drove about 3 mins down the road to get fuel and boom!!!  Anyway, I have a few questions and hope you fine people can help me out here. All questions are in red. 1. The solenoids: I was looking at the parts catalogue in Amayama and I could only find the Solenoids as an assembly. https://www.amayama.com/en/part/nissan/319404ax05 I read in another thread that Solenoid A = 31940-4AX02 & Solenoid B = 31940-4AX05 but the Amayama product has only the code of B. Is this the right part? Can anyone who has done the Solenoid changes or seen them confirm if this is the complete set of A & B?   2. Gasket and Filter: I'm not going to try change the solenoids myself because it seems difficult to do in a home garage with just 2 jack stands. I plan to take it to a shop and get it changed. I was also going to buy the transmission sump gasket at the same time so I don't reuse the same gasket. Should I just use the existing gasket as it has only been on the car since OCT 19th? (~3 weeks) Should I be buying a brand-new gasket and a filter? Does this job involve taking the filter out?   Thanks in advance to everyone. It's hard to find a video of someone doing a solenoid change on a R34 so any help you can give answering my remaining questions would make me less stressed.
    • Kinkstaah
      R34 GTT RB rough idle problem with weird RPM gauge fluctuations

      By Kinkstaah · Posted

      Yea - From what I have seen from the video, the car idles like any R34 lol 50PSI of fuel pressure is hardly super abnormal, the regulator is working because the pressure remains static when the throttle gets revved, i.e pressure remains the same when manifold vaccuum changes. Bigger pumps on stock rails always bumped the pressure in the rail without using an aftermarket regulator to change that. Do you know what your IAC is actually doing? Has there been any data showing the stepper motor % etc? There's no way your idle is actually moving around the way the cluster(s) are indicating. You would hear the difference with the engine RPM flying to 3k and 1k in mere seconds. I'd be checking the wiring to the tacho. What the tacho is telling you and what the engine/ecu is telling you are different things. I assume your ECU doesn't display the spike. So whatever is telling the tacho to be at X rpm is doing something weird. When the going gets insane, you're on the wrong path. You've ruled out plenty of things that are working correctly/aren't the issue. Your idle isn't doing what the tacho is indicating. You have two seperate issues, I don't think they are linked, and the idle seems reasonably okay unless it's stalling which.. well, it hasn't. Troubleshoot the stall if it occurs by figuring out what your IAC is doing vs what it is being told to do.
    • PranK
      R’s Meet - Fuji speedway 2024

      By PranK · Posted

      So awesome! I love the RB with the exhaust on display.
×
×
  • Create New...