Jump to content
SAU Community

Recommended Posts

Hi all,

Yesterday morning I checked the coolant and it had some brown discolouration (see pic).

I have drained the radiator and flushed it out with water.

A large amount of this stuff came out.

Whilst bleeding the coolant, more brown stuff came out.

I closed it off and revved the engine, where upon bits were coming up through the radiator.

I drove the car around for roughly 30-40 minutes, and re-checked when cool. There was minimal brown stuff inside the radiator (pretty much as much as you can see in the pic).

Notes on old mate 'brown stuff':

- It floats

- I couldn't work out the smell, it didn't smell like oil. I run e85 so I'm not sure whether it could be that.

- It has a very silky feel to it

Other notes:

There's no condensation or coolant coming through the exhaust

The oil level did not seem to drop at all, nor has it dropped over the last month

Any help or opinions would be greatly appreciated!

Pic: http://i991.photobucket.com/albums/af34/Godsillah/DSC03579_zpsd7bbd9a2.jpg

..

what i would do

get some radiator flush..run it through the system as per instructions with heater on.....drain....

disconnect top radiator hose and put a hose in the top of the radiator...run the engine with heater on so water form the hose flushes through and drains onto ground from disconnected hose.......do this till water looks fresh....could take a while...

then fill with coolant and drive....if problem persists you may have another issue

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I was just going through this on Neil's car (33 gtst). Assuming you are using standard AAC and Cold start valves, you need Post Turbo Pre throttle to Boost Controller (if you have one) then to Turbo Wastegate Pre throttle to AAC input AAC input T piece to Cold start input Cold start output to plenum post throttle AAC Output to plenum post throttle AAC Output to brake booster (needs a 1 way valve) Plenum post throttle to Fuel Pressure Regulator Plenum post throttle to Blow off valve signal Plenum post throttle to Boost controller input (if you have one)
    • I’m trying to figure out the purpose of these fittings. Assuming they’re for coolant but not sure where the lead to. I know the bigger one on the right (which isn’t filled) is the brake booster. If anyone has a photo of a diagram of this intake or has a set of instructions it’d be greatly appreciated 
    • How much is that r32? Is that $170k or $1.7m 
    • Ahhh! My silly brain was thinking Nissan started selling them straight away, but they waited w or three years didn't they?   Maybe Duncan should build an R35 race car over the V37... There's a cheap yellow one on car sales Duncan, would only need your splash of purple added...
    • Welcome (back) Gaston! Keep us up to date with the hunt!
×
×
  • Create New...