Jump to content
SAU Community

[Nsw]Ssr Sp3 In Custom Bronze 19X11 +3 And -1 With 275/30 All Round

dlai
 Share

Recommended Posts

dlai Enthusiast

dlai

Posted
Posted
For sale: SSR SP3 in custom bronze 19x11 +3 and -1 with 275/30 all round => Tyres are Falken 452 on the rear with 98% tread and the fronts are Dunlop Direzza DZ101 with 80% tread

Price and price conditions: $4300 with tyres, $3800 without tyres

Condition: Almost new, I had these made this year in June 2013. One wheel has very slight rash from a brick in my driveway but I can get it fixed for you for $60

Contact Details: 0421209840

Location: Concord, NSW

Delivery & Conditions of Delivery: Will consider shipping interstate but I prefer local sale

Comments: These fit my GTR R34 with no clearance issues on stock guards with my car as low as you see in the pictures. It took me a long time to work out the size, offset and wheel size/type to buy to make it work with minimal room for error :)

Pictures:

1397077_676839668993486_906364382_o.jpg

1003542_618950901471219_390097460_n.jpg

994948_544116275662401_1564596401_n.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • hypergear
      Blue/grey smoke after idle

      By hypergear 路 Posted

      Steam valve seals are usually responsible for cold start smoke, it goes away once engine warmed up. Disconnect it let engine breathers and let it breath freely, see if problem goes away after a short drive. Also check to make sure engine oil drain pipe is not blocked or kinked. 
    • TurboTapin
      R32 GTST - 600KW+ RB28/CD009 Build

      By TurboTapin 路 Posted

      Haha thanks! Yea I'm moving over from 2x 1000cc jets pre throttle over to 6x 190cc direct port jets and 1x 500cc pre throttle jet.  Direct port comes with all the advantages you would expect, except that pre throttle does cool down IAT'S more. That's why my direct port nozzle placement is closest to the plenum as possible in the runners to allow the air more time to cool before being sucked in. I'm also putting that one 500cc pre throttle jet to help with more cooling. It's a hybrid system. There's a lot more advantages to moving over to a PWM solenoid with a constant pressure system vs my old PWM pump setup, but I'll get more into that once I'm done converting everything over. The ricer in me is excited to see SS tubing all over my manifold though!
    • Dose Pipe Sutututu
      R32 GTST - 600KW+ RB28/CD009 Build

      By Dose Pipe Sutututu 路 Posted

      Very cool, see what I did there? 馃ゲ Wild WMI setup, first I've seen where it's on each cylinder runner, usually I see a single jet pre throttle.
    • Milkmun
      Hello fellow enthusiasts

      By Milkmun 路 Posted

      Welcome mate. What type of work were you looking at getting done? Majorly of decent skyline workshops are in the SE.
    • TheBushKangaroo
      Hello fellow enthusiasts

      By TheBushKangaroo 路 Posted

      Thanks mate, haha that's it ey, no more boosters and what not, should make for a good time
脳
脳
  • Create New...